Show simple item record

contributor authorYan, Xueying
contributor authorCarriveau, Rupp
contributor authorTing, David S. K.
date accessioned2019-02-28T11:00:12Z
date available2019-02-28T11:00:12Z
date copyright1/9/2018 12:00:00 AM
date issued2018
identifier issn0098-2202
identifier otherfe_140_05_054502.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4251618
description abstractWhen buoyant vortex rings form, azimuthal disturbances occur on their surface. When the magnitude of the disturbance is sufficiently high, the ring will become turbulent. This paper establishes conditions for categorization of a buoyant vortex ring as laminar, transitional, or turbulent. The transition regime of enclosed-air buoyant vortex rings rising in still water was examined experimentally via two high-speed cameras. Sequences of the recorded pictures were analyzed using matlab. Key observations were summarized as follows: for Reynolds number lower than 14,000, Bond number below 30, and Weber number below 50, the vortex ring could not be produced. A transition regime was observed for Reynolds numbers between 40,000 and 70,000, Bond numbers between 120 and 280, and Weber number between 400 and 800. Below this range, only laminar vortex rings were observed, and above, only turbulent vortex rings.
publisherThe American Society of Mechanical Engineers (ASME)
titleLaminar to Turbulent Buoyant Vortex Ring Regime in Terms of Reynolds Number, Bond Number, and Weber Number
typeJournal Paper
journal volume140
journal issue5
journal titleJournal of Fluids Engineering
identifier doi10.1115/1.4038661
journal fristpage54502
journal lastpage054502-5
treeJournal of Fluids Engineering:;2018:;volume( 140 ):;issue: 005
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record