Analysis of Strip Footings on Fiber-Reinforced Slopes with the Aid of Particle Image Velocimetry

Abstract

This paper provides results of a comprehensive investigation into the use of waste carpet fibers for reinforcement of clay soil slopes. The interaction between laboratory scale model slopes made of fiber-reinforced clay soil and surface strip footing load was examined. Results for the influence of two variables, namely fiber content and distance between the footing edge and the crest of the slope, are presented and discussed. The particle image velocimetry (PIV) technique was used to study the deformation of the slope under the surface loading. The front side of the tank was made of a thick Perspex glass to facilitate taking accurate images during the loading stage. To study the stress induced in the slope under footing pressure, excess pore-water pressure and total stress increase were measured at predetermined locations within the slope. The results showed that fiber reinforcement increased the bearing resistance of the model slope significantly. For instance, inclusion of 5% waste carpet fiber increased the bearing pressure by 145% at a 10% settlement ratio.