| description abstract | This paper presents a continued study on a previously investigated novel winglet-shroud (WS) (or partial shroud) geometry for a linear turbine cascade. Various widths of double-side winglets (DSW) and different locations of a partial shroud are considered. In addition, both a plain tip and a full shroud tip are applied as the datum cases which were examined experimentally and numerically. Total pressure loss and viscous loss coefficients are comparatively employed to execute a quantitative analysis of aerodynamic performance. The effectiveness of various widths (w) of DSW set at 3%, 5%, 7%, and 9% of the blade pitch (p) is numerically investigated. Skin-friction lines on the tip surface indicate that different DSW cases do not alter flow field features including the separation bubble and reattachment flow within the tip gap region, even for the case with the broadest width (w/p = 9%). However, the pressure side extension of the DSW exhibits the formation of separation bubble, while the suction side platform of the DSW turns the tip leakage vortex (TLV) away from the suction surface (SS). Meanwhile, the horse-shoe vortex (HV) near the casing is not generated even for the case with the smallest width (w/p = 3%). As a result, both the tip leakage and the upper passage vortices are weakened and further dissipated with wider w/p in the DSW cases. Larger width of the DSW geometry is indeed able to improve the aerodynamic performance, but only to a slight degree. With the w/p increasing from 3% to 9%, the mass-averaged total pressure loss coefficient over an exit plane is reduced by only 2.61%. Therefore, considering both the enlarged (or reduced) tip area and the enhanced (or deteriorated) performance compared to the datum cases, a favorable width of w/p = 5% is chosen to design the WS structure. Three locations for the partial shroud (linkage segment) are devised, locating them near the leading edge, in the middle and close to the trailing edge, respectively. Results demonstrate that all three cases of the WS design have advantages over the DSW arrangement in lessening the aerodynamic loss, with the middle linkage segment location producing the optimal effect. This conclusion verifies the feasibility of the previously studied WS configuration. | |
