Airborne Rain-Rate Measurement with a Wide-Swath Radar Altimeter

Abstract

he NOAA Wide-Swath Radar Altimeter (WSRA) uses 80 narrow beams spread over ±30° in the cross-track direction to generate raster lines of sea surface topography at a 10-Hz rate from which sea surface directional wave spectra are produced. A ±14° subset of the backscattered power data associated with the topography measurements is used to produce independent measurements of rain rate and sea surface mean square slope at 10-s intervals. Theoretical calculations of rain attenuation at the WSRA 16.15-GHz operating frequency using measured drop size distributions for both mostly convective and mostly stratiform rainfall demonstrate that the WSRA absorption technique for rain determination is relatively insensitive to both ambient temperature and the characteristics of the drop size distribution, in contrast to reflectivity techniques. The variation of the sea surface radar reflectivity in the vicinity of a hurricane is reviewed. Fluctuations in the sea surface scattering characteristics caused by changes in wind speed or the rain impinging on the surface cannot contaminate the rain measurement because they are calibrated out using the WSRA measurement of mean square slope. WSRA rain measurements from a NOAA WP-3D hurricane research aircraft off the North Carolina coast in Hurricane Irene on 26 August 2011 are compared with those from the stepped frequency microwave radiometer (SFMR) on the aircraft and the Next Generation Weather Radar (NEXRAD) National Mosaic and Multi-Sensor Quantitative Precipitation Estimation (QPE) system.