Aircraft Evaluation of Ground-Based Raman Lidar Water Vapor Turbulence Profiles in Convective Mixed Layers

Abstract

igh temporal and vertical resolution water vapor measurements by Raman and differential absorption lidar systems have been used to characterize the turbulent fluctuations in the water vapor mixing ratio field in convective mixed layers. Since daytime Raman lidar measurements are inherently noisy (due to solar background and weak signal strengths), the analysis approach needs to quantify and remove the contribution of the instrument noise in order to derive the desired atmospheric water vapor mixing ratio variance and skewness profiles. This is done using the approach outlined by Lenschow et al.; however, an intercomparison with in situ observations was not performed.Water vapor measurements were made by a diode laser hygrometer flown on a Twin Otter aircraft during the Routine Atmospheric Radiation Measurement (ARM) Program Aerial Facility Clouds with Low Optical Water Depths Optical Radiative Observations (RACORO) field campaign over the ARM Southern Great Plains (SGP) site in 2009. Two days with Twin Otter flights were identified where the convective mixed layer was quasi stationary, and hence the 10-s, 75-m data from the SGP Raman lidar could be analyzed to provide profiles of water vapor mixing ratio variance and skewness. Airborne water vapor observations measured during level flight legs were compared to the Raman lidar data, demonstrating good agreement in both variance and skewness. The results also illustrate the challenges of comparing a point sensor making measurements over time to a moving platform making similar measurements horizontally.