Turbulent Velocity-Variance Profiles in the Stable Boundary Layer Generated by a Nocturnal Low-Level Jet

Abstract

Profiles of mean winds and turbulence were measured by the High Resolution Doppler lidar in the strong-wind stable boundary layer (SBL) with continuous turbulence. The turbulence quantity measured was the variance of the streamwise wind velocity component σ2u. This variance is a component of the turbulence kinetic energy (TKE), and it is shown to be numerically approximately equal to TKE for stable conditions?profiles of σ2u are therefore equivalent to profiles of TKE. Mean-wind profiles showed low-level jet (LLJ) structure for most of the profiles, which represented 10-min averages of mean and fluctuating quantities throughout each of the six nights studied. Heights were normalized by the height of the first LLJ maximum above the surface ZX, and the velocity scale used was the speed of the jet UX, which is shown to be superior to the friction velocity u* as a velocity scale. The major results were 1) the ratio of the maximum value of the streamwise standard deviation to the LLJ speed σu/UX was found to be 0.05, and 2) the three most common σ2u profile shapes were determined by stability (or Richardson number Ri). The least stable profile shapes had the maximum σ2u at the surface decreasing to a minimum at the height of the LLJ; profiles that were somewhat more stable had constant σ2u through a portion of the subjet layer; and the most stable of the profiles had a maximum of σ2u aloft, although it is important to note that the Ri for even the most stable of the three profile categories averaged less than 0.20. The datasets used in this study were two nights from the Cooperative Atmosphere?Surface Exchange Study 1999 campaign (CASES-99) and four nights from the Lamar Low-Level Jet Project, a wind-energy experiment in southeast Colorado, during September 2003.