Surface Forcing of the Infrared Cooling Profile over the Tibetan Plateau. Part I: Influence of Relative Longwave Radiative Heating at High Altitude

Abstract

The role of the Tibetan Plateau on the behavior of the surface longwave radiation budget is examined, and the behavior of the vertical profile of longwave cooling over the plateau, including its diurnal variation, is quantified. The investigation has been conducted with the aid of datasets obtained during the 1986 Tibetan Plateau Meteorological Experiment (TIPMEX-86). A medium spectral-resolution infrared radiative transfer model using a simple modification for applications in idealized complex (valley) terrain is developed for the study. This study focuses on the clear-sky case where the surface effects are most significant. The TIPMEX-86 data, obtained during the spring-summer transition into the East Asian monsoon season, are used to help validate the surface longwave radiation budget at two sites of varying elevation: Lasa (3650 m) and Naqu (4500 m). Based on the degree to which skin-temperature boundary conditions control the magnitude of infrared cooling, we define the concept of relative longwave heating and explain its influence on the vertical infrared cooling-rate profile. Relative longwave radiative heating at the higher-elevation Naqu site is found to be twice as large as that corresponding to the lower-elevation Lasa site located within a valley. Besides reducing the infrared cooling rates, it is shown that relative longwave heating extends the period of the day over which the plateau acts as a direct heat source to the atmosphere. Computational results from the infrared model help substantiate observational analyses that indicate surface longwave net radiation at the high-elevation site, on clear days, exceeds 300 W m?2; this is an order of magnitude greater than typical of sea-level oceanic conditions. As a result of the unique meteorological and surface conditions, total infrared flux convergence occurs within the deep planetary boundary layer (i.e., infrared heating of the cloud-free lower atmosphere) at the high-elevation site during the afternoon. An important characteristic of the daytime longwave heating process of the lower layers is how it turns off like a switch at approximately 1800 MST, transforming almost immediately to maximum cooling of the lower layers. Atmospheric longwave cooling is significantly influenced by variations in the biophysical composition of the surface and the associated thermal diurnal cycle. It is estimated that natural variations of surface emissivity could modulate longwave cooling by up to 40%. The largest impact would occur at a time when the surface temperature is high and the relative longwave radiative heating of the lower atmosphere by the surface reaches its maximum value.