| description abstract | In this study, aluminized and NiCrAlY plasmasprayed AISI 310 stainless steel samples were tested in supercritical water (SCW) at 500آ°C. The microstructure after SCW exposure was analyzed using scanning electron microscopy (SEM), energydispersive spectroscopy (EDS), and Xray diffraction (XRD). Weight measurements were taken before and after exposure to provide quantitative comparison of the two coatings on AISI 310 base metal. The results showed that aluminized and bare 310 stainless steel experienced similar weight gain, in the range of 0.02–0.08  mg/cm2 after 1550آ hr. The aluminized sample had a slight weight decrease as exposure progressed. Oxide formation, in the forms of Al2O3 and (Fe,Cr)2O3, was found on the aluminized surface along with surface cracking after 1550آ hr testing in SCW. NiCrAlYcoated 310, however, had the most consistent weight increase and oxide formation (mainly Al2O3) on the surface. Based on the results from this study, the aluminized coating has limitations in providing surface protection due to surface cracking and weight loss. The NiCrAlY plasmasprayed coating with alumina formation on the surface has the potential to provide longterm surface protection to the substrate material in SCW. | |
