Show simple item record

contributor authorJackson, Jennifer N.
contributor authorHass, Chris J.
contributor authorFregly, Benjamin J.
date accessioned2017-05-09T01:26:17Z
date available2017-05-09T01:26:17Z
date issued2016
identifier issn0148-0731
identifier otherbio_138_09_091002.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/160443
description abstractComputational walking simulations could facilitate the development of improved treatments for clinical conditions affecting walking ability. Since an effective treatment is likely to change a patient's footground contact pattern and timing, such simulations should ideally utilize deformable footground contact models tailored to the patient's foot anatomy and footwear. However, no study has reported a deformable modeling approach that can reproduce all six ground reaction quantities (expressed as three reaction force components, two center of pressure (CoP) coordinates, and a free reaction moment) for an individual subject during walking. This study proposes such an approach for use in predictive optimizations of walking. To minimize complexity, we modeled each foot as two rigid segments—a hindfoot (HF) segment and a forefoot (FF) segment—connected by a pin joint representing the toes flexion–extension axis. Ground reaction forces (GRFs) and moments acting on each segment were generated by a grid of linear springs with nonlinear damping and Coulomb friction spread across the bottom of each segment. The stiffness and damping of each spring and common friction parameter values for all springs were calibrated for both feet simultaneously via a novel threestage optimization process that used motion capture and ground reaction data collected from a single walking trial. The sequential threestage process involved matching (1) the vertical force component, (2) all three force components, and finally (3) all six ground reaction quantities. The calibrated model was tested using four additional walking trials excluded from calibration. With only small changes in input kinematics, the calibrated model reproduced all six ground reaction quantities closely (root mean square (RMS) errors less than 13 N for all three forces, 25 mm for anterior–posterior (AP) CoP, 8 mm for medial–lateral (ML) CoP, and 2 Nآ·m for the free moment) for both feet in all walking trials. The largest errors in AP CoP occurred at the beginning and end of stance phase when the vertical ground reaction force (vGRF) was small. Subjectspecific deformable footground contact models created using this approach should enable changes in footground contact pattern to be predicted accurately by gait optimization studies, which may lead to improvements in personalized rehabilitation medicine.
publisherThe American Society of Mechanical Engineers (ASME)
titleDevelopment of a Subject Specific Foot Ground Contact Model for Walking
typeJournal Paper
journal volume138
journal issue9
journal titleJournal of Biomechanical Engineering
identifier doi10.1115/1.4034060
journal fristpage91002
journal lastpage91002
identifier eissn1528-8951
treeJournal of Biomechanical Engineering:;2016:;volume( 138 ):;issue: 009
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record