Show simple item record

contributor authorM. Kolivand
contributor authorA. Kahraman
date accessioned2017-05-09T00:45:58Z
date available2017-05-09T00:45:58Z
date copyrightJanuary, 2011
date issued2011
identifier issn1050-0472
identifier otherJMDEDB-27937#014503_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/147121
description abstractDetermining the locations and orientation of potential instantaneous contact lines between two contacting tooth surfaces of gears is one major step in the prediction of unloaded and loaded gear tooth contacts. This study defines and utilizes new general concept based on the construction of a surface of roll angle to simplify the task of locating instantaneous contact lines of any type of gearing. The position and normal vectors of points on one of the mating surfaces and axes of both gears are used in conjunction with the equation of meshing to define the surface of action and the surface of roll angle. With the surface of roll angle defined, instantaneous contact lines are determined by a novel approach based on an analogy to parallel-axes gears. At the end, the proposed method is applied to various parallel- and cross-axis gear pairs to demonstrate its effectiveness.
publisherThe American Society of Mechanical Engineers (ASME)
titleA General Approach to Locate Instantaneous Contact Lines of Gears Using Surface of Roll Angle
typeJournal Paper
journal volume133
journal issue1
journal titleJournal of Mechanical Design
identifier doi10.1115/1.4003142
journal fristpage14503
identifier eissn1528-9001
keywordsGears
treeJournal of Mechanical Design:;2011:;volume( 133 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record