Show simple item record

contributor authorNelly Andarawis-Puri
contributor authorAndrew F. Kuntz
contributor authorMatthew L. Ramsey
contributor authorLouis J. Soslowsky
date accessioned2017-05-09T00:42:35Z
date available2017-05-09T00:42:35Z
date copyrightMarch, 2011
date issued2011
identifier issn0148-0731
identifier otherJBENDY-27200#031008_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/145475
description abstractSupraspinatus tendon tears are common and often propagate into larger tears that include the infraspinatus tendon, resulting in loss of function and increased pain. Previously, we showed that the supraspinatus and infraspinatus tendons mechanically interact through a range of rotation angles, potentially shielding the torn supraspinatus tendon from further injury while subjecting the infraspinatus tendon to increased risk of injury. Surgical repair of torn supraspinatus tendons is common, yet the effect of the repair on the infraspinatus tendon is unknown. Since we have established a relationship between strain in the supraspinatus and infraspinatus tendons the success of a supraspinatus tendon repair depends on its effect on the loading environment in the infraspinatus tendon. More specifically, the effect of transosseous supraspinatus tendon repair in comparison to one that utilizes suture anchors, as is commonly done with arthroscopic repairs, on this interaction through these joint positions will be evaluated. We hypothesize that at all joint positions evaluated, both repairs will restore the interaction between the two tendons. For both repairs, (1) increasing supraspinatus tendon load will increase infraspinatus tendon strain and (2) altering the rotation angle from internal to external will increase strain in the infraspinatus tendon. Strains were measured in the infraspinatus tendon insertion through a range of joint rotation angles and supraspinatus tendon loads, for the intact, transosseous, and suture anchor repaired supraspinatus tendons. Images corresponding to specific supraspinatus tendon loads were isolated for the infraspinatus tendon insertion for analysis. The effect of supraspinatus tendon repair on infraspinatus tendon strain differed with joint position. Altering the joint rotation did not change strain in the infraspinatus tendon for any supraspinatus tendon condition. Finally, increasing supraspinatus tendon load resulted in an increase in average maximum and decrease in average minimum principal strain in the infraspinatus tendon. There is a significant difference in infraspinatus tendon strain between the intact and arthroscopically (but not transosseous) repaired supraspinatus tendons that increases with greater loads. Results suggest that at low loads neither supraspinatus tendon repair technique subjects the infraspinatus tendon to potentially detrimental loads; however, at high loads, transosseous repairs may be more advantageous over arthroscopic repairs for the health of the infraspinatus tendon. Results emphasize the importance of limiting loading of the repaired supraspinatus tendon and that at low loads, both repair techniques restore the interaction to the intact supraspinatus tendon case.
publisherThe American Society of Mechanical Engineers (ASME)
titleEffect of Supraspinatus Tendon Repair Technique on the Infraspinatus Tendon
typeJournal Paper
journal volume133
journal issue3
journal titleJournal of Biomechanical Engineering
identifier doi10.1115/1.4003326
journal fristpage31008
identifier eissn1528-8951
keywordsMaintenance
keywordsStress
keywordsTendons
keywordsRotation AND Arthroscopy
treeJournal of Biomechanical Engineering:;2011:;volume( 133 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record