| description abstract | An improved version of the analytical solutions by , and co-workers (1991, “Some Results on Analytical Solution of Cylindrical Shells With Large Opening,” ASME J. Pressure Vessel Technol., 113, 297–307; 1991, “The Stress Analysis of Cylindrical Shells With Rigid Inclusions Having a Large Ratio of Radii,” SMiRT 11 Transactions F, F05/2, 85–90; 1995, “The Thin Theoretical Solution for Cylindrical Shells With Large Openings,” Acta Mech. Sin., 27(4), pp. 482–488; 1995, “Stresses at the Intersection of Two Cylindrical Shells,” Nucl. Eng. Des., 154, 231–238; 1996, “A Reinforcement Design Method Based on Analysis of Large Openings in Cylindrical Pressure Vessels,” ASME J. Pressure Vessel Technol., 118, 502–506; 1999, “Analytical Solution for Cylindrical Thin Shells With Normally Intersecting Nozzles Due to External Moments on the Ends of Shells,” Sci. China, Ser. A: Math., Phys., Astron., 42(3), 293–304; 2000, “Stress Analysis of Cylindrical Shells With Nozzles Due to External Run Pipe Moments,” J. Strain Anal. Eng. Des., 35, 159–170; 2004, “Analytical Solution of Two Intersecting Cylindrical Shells Subjected to Transverse Moment on Nozzle,” Int. J. Solids Struct., 41(24–25), 6949–6962; 2005, “A Thin Shell Theoretical Solution for Two Intersecting Cylindrical Shells Due to External Branch Pipe Moments,” ASME J. Pressure Vessel Technol., 127(4), 357–368; 2005, “Theoretical Stress Analysis of Two Intersecting Cylindrical Shells Subjected to External Loads Transmitted Through Branch Pipes,” Int. J. Solids Struct., 42, 3299–3319) for two normally intersecting cylindrical shells is presented, and the applicable ranges of the theoretical solutions are successfully extended from d/D≤0.8 and λ=d/(DT)1/2≤8 to d/D≤0.9 and λ≤12. The thin shell theoretical solution is obtained by solving a complex boundary value problem for a pair of fourth-order complex-valued partial differential equations (exact Morley equations (, 1959, “An Improvement on Donnell’s Approximation for Thin Walled Circular Cylinders,” Q. J. Mech. Appl. Math.12, 89–91; , 1966, “A Set of Simple, Accurate Equations for Circular Cylindrical Elastic Shells,” Int. J. Solids Struct., 2, 525–541)) for the shell and the nozzle. The accuracy of results is improved by some additional terms to the expressions for resultant forces and moments in terms of complex-valued displacement-stress function. The theoretical stress concentration factors due to internal pressure obtained by the improved expressions are in agreement with previously published test results. The theoretical results discussed and presented herein are in sufficient agreement with those obtained from three dimensional finite element analyses for all the seven load cases, i.e., internal pressure and six external branch pipe load components involving three orthogonal forces and the respective three orthogonal moments. | |
