Experiments on the Physical Mechanism of Heat Transfer Augmentation by Freestream Turbulence at a Cylinder Stagnation Point

Abstract

Detailed time records of velocity and heat flux were measured near the stagnation point of a cylinder in low-speed airflow. The freestream turbulence was controlled using five different grids positioned to match the characteristics from previous heat flux experiments at NASA Glenn using the same wind tunnel. A hot wire was used to measure the cross-flow velocity at a range of positions in front of the stagnation point. This gave the average velocity and fluctuating component including the turbulence intensity and integral length scale. The heat flux was measured with a heat flux microsensor located on the stagnation line underneath the hot-wire probe. This gave the average heat flux and the fluctuating component simultaneous with the velocity signal, including the heat flux turbulence intensity and the coherence with the velocity. The coherence between the signals allowed identification of the crucial positions for measurement of the integral length scale and turbulence intensity for prediction of the time-averaged surface heat flux. The frequencies corresponded to the most energetic frequencies of the turbulence, indicating the importance of the penetration of the turbulent eddies from the freestream through the boundary layer to the surface. The distance from the surface was slightly less than the local value of length scale, indicating the crucial role of the turbulence in augmenting the heat flux. The resulting predictions of the analytical model matched well with the measured heat transfer augmentation.