Show simple item record

contributor authorZhaoming He
contributor authorChristopher Jowers
date accessioned2017-05-09T00:31:52Z
date available2017-05-09T00:31:52Z
date copyrightJanuary, 2009
date issued2009
identifier issn0148-0731
identifier otherJBENDY-26856#014501_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/140045
description abstractProper leaflet coaptation of the mitral valve is vital for a healthy functioning heart. Chordal tension directly affects leaflet coaptation. The C-shaped transducer used previously to measure chordal tension was too big for tension measurement of multiple chordae and their branches. A new method is needed to measure chordal tension with minimum interference with chord and leaflet motion. The method was to extrapolate longitudinal chordal tension from transverse chordal fibril force measured by inserting a small elliptical AIFP4 sensor from MicroStrain Inc. (Williston, VT) through a chord. Sensitivity of the method has been tested with the sensor implanted in chordae, and error of the method has been estimated at various sensor deviation angles. Intact porcine and ovine hearts were used to measure mitral valve strut and marginal chordal tensions at static transmitral pressures of 120mmHg and 160mmHg under an in vitro condition. The results obtained from the AIFP4 sensor were similar to the results obtained previously by C-shaped transducers in the porcine mitral valves. The sensor output errors increased with the increase in sensor deviation angle in the chord at a peak systolic tension. Strut chordal tensions of four ovine mitral valves of Edwards ring size M 28 were 0.29±0.06N at the transmitral pressure of 120mmHg. The tension of 18 porcine strut chordae of porcine mitral valves of Edwards ring size M 32 was 1.00±0.42N at the transmitral pressures of 120mmHg. The tension of 22 anterior leaflet marginal chordae from porcine mitral valves of Edwards ring size M 32 was 0.10±0.04N at the transmitral pressure of 120mmHg. A new method using an AIFP4 miniature force sensor to measure mitral valve chordal tension indirectly is successfully developed. This force sensor works well in measuring mitral valve chordal tension at an in vitro hydrostatic transmitral pressure. The size and simple fixation of the sensor make it favorable for chordal tension measurement of multiple chordae and their branches under in vitro or in vivo conditions with minimal interference with chordal geometry and dynamics.
publisherThe American Society of Mechanical Engineers (ASME)
titleA Novel Method to Measure Mitral Valve Chordal Tension
typeJournal Paper
journal volume131
journal issue1
journal titleJournal of Biomechanical Engineering
identifier doi10.1115/1.3005160
journal fristpage14501
identifier eissn1528-8951
keywordsSensors
keywordsStruts (Engineering)
keywordsTransducers
keywordsValves
keywordsTension
keywordsErrors
keywordsChords (Trusses)
keywordsBifurcation
keywordsForce sensors AND Force
treeJournal of Biomechanical Engineering:;2009:;volume( 131 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record