Show simple item record

contributor authorMaciej M. Opoka
contributor authorRichard L. Thomas
contributor authorHoward P. Hodson
date accessioned2017-05-09T00:30:51Z
date available2017-05-09T00:30:51Z
date copyrightApril, 2008
date issued2008
identifier issn0889-504X
identifier otherJOTUEI-28745#021009_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/139508
description abstractThis paper presents the results of an experimental study of the interaction between the suction surface boundary layer of a cascade of low-pressure (LP) turbine blades and a fluctuating downstream potential field. A linear cascade equipped with a set of T106 LP turbine blades was subjected to a periodic variation of the downstream pressure field by means of a moving bar system at low-speed conditions. Measurements were taken in the suction surface boundary layer using 2D laser Doppler anemometry, flush-mounted unsteady pressure transducers and surface shear stress sensors. The Reynolds number, based on the chord and exit conditions, was 1.6×105. The measurements revealed that the magnitudes of the suction surface pressure variations induced by the oscillating downstream pressure field, just downstream of the suction peak, were approximately equal to those measured in earlier studies involving upstream wakes. These pressure field oscillations induced a periodic variation of the transition onset location in the boundary layer. Two turbulence levels were investigated. At a low level of inlet freestream turbulence of 0.5%, a separation bubble formed on the rear part of the suction surface. Unsteady measurements of the surface pressure revealed the presence of high-frequency oscillations occurring near the start of the pressure recovery region. The amplitude of these fluctuations was of the order of 7–8% of exit dynamic pressure, and inspection of the velocity field revealed the presence of Kelvin-Helmholtz-type shear layer vortices in the separated free shear layer. The frequency of these shear layer vortices was approximately one order-of-magnitude greater than the frequency of the downstream passing bars. At a higher inlet freestream turbulence level of 4.0%, which is more representative of real engine environments, separation was prevented by an earlier onset of transition. Oscillations were still observed in suction surface shear stress measurements at a frequency matching the period of the downstream bar, indicating a continued influence on the boundary layer from the oscillating pressure field. However, the shear layer vortices seen in the lower turbulence intensity case were not so clearly observed, and the maximum amplitude of suction surface pressure fluctuations was reduced.
publisherThe American Society of Mechanical Engineers (ASME)
titleBoundary Layer Transition on the High Lift T106A Low-Pressure Turbine Blade With an Oscillating Downstream Pressure Field
typeJournal Paper
journal volume130
journal issue2
journal titleJournal of Turbomachinery
identifier doi10.1115/1.2751142
journal fristpage21009
identifier eissn1528-8900
keywordsPressure
keywordsFlow (Dynamics)
keywordsSeparation (Technology)
keywordsTurbulence
keywordsSuction
keywordsTurbine blades
keywordsShear (Mechanics)
keywordsBoundary layers
keywordsBlades
keywordsOscillations
keywordsCascades (Fluid dynamics)
keywordsBubbles
keywordsStress
keywordsWakes AND Reynolds number
treeJournal of Turbomachinery:;2008:;volume( 130 ):;issue: 002
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record