Show simple item record

contributor authorT. A. Camp
contributor authorT. McQuinn
contributor authorK. C. Stewart
contributor authorR. S. Figliola
date accessioned2017-05-09T00:22:48Z
date available2017-05-09T00:22:48Z
date copyrightApril, 2007
date issued2007
identifier issn0148-0731
identifier otherJBENDY-26680#284_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/135270
description abstractGiven the tolerance of the right heart circulation to mild regurgitation and gradient, we study the potential of using motionless devices to regulate the pulmonary circulation. In addition, we document the flow performance of two mechanical valves. A motionless diode, a nozzle, a mechanical bileaflet valve, and a tilting disk valve were tested in a pulmonary mock circulatory system over the normal human range of pulmonary vascular resistance (PVR). For the mechanical valves, regurgitant fractions (RFs) and transvalvular pressure gradients were found to be weak functions of PVR. On the low end of normal PVR, the bileaflet and tilting disk valves fluttered and would not fully close. Despite this anomaly, the regurgitant fraction of either valve did not change significantly. The values for RF and transvalvular gradient measured varied from 4 to 7% and 4to7mmHg, respectively, at 5lpm for all tests. The diode valve was able to regulate flow with mild regurgitant fraction and trivial gradient but with values higher than either mechanical valve tested. Regurgitant fraction ranged from 2 to 17% in tests extending from PVR values of 1to4.5mmHg∕lpm at 5lpm and with concomitant increases in gradient up to 17mmHg. The regurgitant fraction for the nozzle increased from 2 to 23% over the range of PVR with gradients increasing to 18mmHg. The significant findings were: (1) the mechanical valves controlled regurgitation at normal physiological cardiac output and PVR even though they failed to close at some normal values of PVR and showed leaflet flutter; and (2) it may be possible to regulate the pulmonary circulation to tolerable levels using a motionless pulmonary valve device.
publisherThe American Society of Mechanical Engineers (ASME)
titleIn Vitro Study of Flow Regulation for Pulmonary Insufficiency
typeJournal Paper
journal volume129
journal issue2
journal titleJournal of Biomechanical Engineering
identifier doi10.1115/1.2540892
journal fristpage284
journal lastpage288
identifier eissn1528-8951
keywordsFlow (Dynamics)
keywordsValves
keywordsElectrical resistance
keywordsNozzles
keywordsPressure gradient AND Pressure
treeJournal of Biomechanical Engineering:;2007:;volume( 129 ):;issue: 002
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record