Show simple item record

contributor authorS. B. Mishra
contributor authorK. Chandra
contributor authorS. Prakash
date accessioned2017-05-09T00:21:40Z
date available2017-05-09T00:21:40Z
date copyrightJuly, 2006
date issued2006
identifier issn0742-4787
identifier otherJOTRE9-28741#469_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/134695
description abstractDegradation of materials due to solid particle erosion is encountered in a variety of engineering industries, either at room temperature or elevated temperatures. Nickel-based coatings are commonly used in applications where wear resistance, combined with oxidation or hot corrosion resistance, is required. In the present work, NiCrAlY and Ni-20Cr metallic coatings were deposited on an iron-based superalloy by a shrouded plasma spray process. The coatings were characterized by scanning electron microscopy, optical microscopy, microhardness testing, and x-ray diffractometry. Erosion studies were conducted using an air-jet erosion test rig at a velocity of 40ms−1 and impingement angles of 30 and 90deg. Scanning electron microscopy was used to analyze the eroded surfaces. 3D surface roughness profiles of the eroded samples were taken using a Veeco Optical Profilometer. NiCrAlY coatings had slightly lower average porosity and lower microhardness as compared to Ni-20Cr coatings. The observed erosion rate of the NiCrAlY coatings, however was lower than that of the Ni-20Cr coatings at both 30 and 90deg impingement angles. Ni-20Cr coating had shown higher erosion rate at 90deg impingement angle than that at 30deg, whereas the effect of impingement angle on the erosion rate is negligible for plasma sprayed NiCrAlY coating. The higher bond strength of NiCrAlY coating might be one of the major contributing factors for lower erosion rate of NiCrAlY coating as compared to Ni-20Cr coating under the tested conditions. Erosion mechanisms of plasma sprayed coatings are discussed.
publisherThe American Society of Mechanical Engineers (ASME)
titleCharacterization and Erosion Behavior of Plasma Sprayed NiCrAlY and Ni-20Cr Coatings on an Fe-based Superalloy
typeJournal Paper
journal volume128
journal issue3
journal titleJournal of Tribology
identifier doi10.1115/1.2197843
journal fristpage469
journal lastpage475
identifier eissn1528-8897
keywordsCoating processes
keywordsCoatings
keywordsSuperalloys
keywordsPlasmas (Ionized gases)
keywordsErosion
keywordsParticulate matter
keywordsPorosity
keywordsSprays
keywordsMicrohardness AND Bond strength
treeJournal of Tribology:;2006:;volume( 128 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record