Show simple item record

contributor authorManish Sinha
contributor authorAli Pinarbasi
contributor authorJoseph Katz
date accessioned2017-05-09T00:05:08Z
date available2017-05-09T00:05:08Z
date copyrightSeptember, 2001
date issued2001
identifier issn0098-2202
identifier otherJFEGA4-27164#490_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/125388
description abstractParticle Image Velocimetry (PIV) and pressure fluctuation measurements are used for investigating the onset and development of rotating stall within a centrifugal pump having a vaned diffuser. The experiments are performed in a facility that enables measurements between the diffuser vanes, within part of the impeller, in the gap between them and in the volute. The diffuser is also instrumented with pressure transducers that track the circumferential motion of rotating stall in the stator. The timing of low-pass-filtered pressure signals are also used for triggering the acquisition of PIV images. The data include detailed velocity distributions, instantaneous and phase-averaged, at different blade orientations and stall phases, as well as auto- and cross-spectra of pressure fluctuations measured simultaneously in neighboring vane passages. The cross-spectra show that the stall propagation rate is 0.93 Hz, 6.2 percent of the impeller speed, and that the stall travels from the passages located on the exit side of the volute toward the beginning side, crossing the tongue region in the same direction as the impeller, where it diminishes. Under stall conditions the flow in the diffuser passage alternates between outward jetting, when the low-pass-filtered pressure is high, to a reverse flow, when the filtered pressure is low. Being below design conditions, there is a consistent high-speed leakage flow in the gap between the impeller and the diffuser from the exit side to the beginning of the volute. Separation of this leakage flow from the diffuser vane causes the onset of the stall. The magnitude of the leakage and the velocity distribution in the gap depend on the orientation of the impeller blade. Conversely, the flow in a stalled diffuser passage and the occurrence of stall do not vary significantly with blade orientation. With decreasing flow-rate the magnitudes of leakage and reverse flow within a stalled diffuser passage increase, and the stall-cell size extends from one to two diffuser passages.
publisherThe American Society of Mechanical Engineers (ASME)
titleThe Flow Structure During Onset and Developed States of Rotating Stall Within a Vaned Diffuser of a Centrifugal Pump
typeJournal Paper
journal volume123
journal issue3
journal titleJournal of Fluids Engineering
identifier doi10.1115/1.1374213
journal fristpage490
journal lastpage499
identifier eissn1528-901X
keywordsPressure
keywordsFlow (Dynamics)
keywordsImpellers
keywordsDiffusers
keywordsCentrifugal pumps
keywordsBlades
keywordsDesign
keywordsPumps
keywordsSignals AND Leakage
treeJournal of Fluids Engineering:;2001:;volume( 123 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record