| contributor author | Heinz-Bodo Schmiedmayer | |
| contributor author | Josef Kastner | |
| date accessioned | 2017-05-09T00:01:50Z | |
| date available | 2017-05-09T00:01:50Z | |
| date copyright | October, 2000 | |
| date issued | 2000 | |
| identifier issn | 0148-0731 | |
| identifier other | JBENDY-26095#523_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/123337 | |
| description abstract | Errors up to ±30 mm in determining the COP with piezoelectric force plates have been reported in the literature. To compensate for these errors, correction formulas were proposed, based on measurements with single point loads. In this paper, it will be shown that the errors in the COP depend on the load distribution. Two examples are presented: (1) simulated balance study, and (2) different pressure patterns during walking. Accurate corrections can only be made for forces distributed over a small area. Errors are expected to be overcompensated if there are only a few pressure peaks separated by large distances. These errors can be as large as the statistical errors (5.8±3.7 mm) after compensation. For certain situations, it is probably better not to use correction formulas. [S0148-0731(00)01005-0] | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Enhancements in the Accuracy of the Center of Pressure (COP) Determined With Piezoelectric Force Plates Are Dependent on the Load Distribution | |
| type | Journal Paper | |
| journal volume | 122 | |
| journal issue | 5 | |
| journal title | Journal of Biomechanical Engineering | |
| identifier doi | 10.1115/1.1289687 | |
| journal fristpage | 523 | |
| journal lastpage | 527 | |
| identifier eissn | 1528-8951 | |
| keywords | Force | |
| keywords | Pressure | |
| keywords | Stress | |
| keywords | Plates (structures) | |
| keywords | Errors AND Formulas | |
| tree | Journal of Biomechanical Engineering:;2000:;volume( 122 ):;issue: 005 | |
| contenttype | Fulltext | |
