Show simple item record

contributor authorM. Hayashi
contributor authorI. Tanaka
contributor authorK. Iida
contributor authorF. Matsuda
contributor authorM. Sato
date accessioned2017-05-08T23:54:29Z
date available2017-05-08T23:54:29Z
date copyrightAugust, 1997
date issued1997
identifier issn0094-9930
identifier otherJPVTAS-28378#343_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/119257
description abstractFor the purpose of investigating vibration characteristics and fatigue strength of a socket-welded joint, a piping system was mocked-up by assembling a straight pipe of 350 mm nominal diameter and a long pipe of 20 mm nominal diameter consisting of straight pipes and elbows. The one end of the small-diameter piping is connected to the large-diameter pipe at its longitudinal midpoint by socket welding, and the rest is supported at several supporting points, the locations of which are changed as an experimental parameter. The materials of the small-diameter piping are carbon and stainless steels. The small-diameter piping was subjected to nearly resonant vibration with the frequency of about 11 Hz by a sinusoidal vibration load applied to the large-diameter pipe. The vibrating displacement amplitude measured on the actual piping was basically 0.05 mm in resonant condition; but the displacement was changed to obtain an S-N curve for the socket-welded joint in the fatigue life range of 104 to 107 cycles. In the mocked-up specimens, fatigue cracks were initiated from the toe of the socket-fillet welds at higher stress amplitude, but from the fillet root at lower stress amplitude. Comparative fatigue tests of straight shape socket-welded specimens fabricated with 20 mm nominal diameter pipe of the same material as used in the mocked-up specimen were carried out under four-point bending condition. The fatigue strength of the socket-welded joint in the mocked-up specimen was about 15 percent lower than that of the simple specimen fatigued by four-point bending load. The reason for this difference is probably due to the triaxial stress condition and three-dimensional restraint condition. The strain gage measurement showed that the shear stress was about 40 percent of the bending stress in the case of the mockedup specimen. In addition, vibration tests of the piping system showed good agreement between experimental and analytical results of vibration behavior.
publisherThe American Society of Mechanical Engineers (ASME)
titleVibration Behavior and Fatigue Strength of Mocked-Up Piping System
typeJournal Paper
journal volume119
journal issue3
journal titleJournal of Pressure Vessel Technology
identifier doi10.1115/1.2842314
journal fristpage343
journal lastpage350
identifier eissn1528-8978
keywordsVibration
keywordsFatigue strength
keywordsPiping systems
keywordsPipes
keywordsStress
keywordsDisplacement
keywordsFatigue cracks
keywordsFatigue life
keywordsFatigue testing
keywordsShapes
keywordsStainless steel
keywordsStrain gages
keywordsShear (Mechanics)
keywordsWelded joints
keywordsVibration tests
keywordsBending (Stress)
keywordsCarbon
keywordsWelding AND Cycles
treeJournal of Pressure Vessel Technology:;1997:;volume( 119 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record