| contributor author | X. D. Liu | |
| contributor author | K. Y. Lam | |
| contributor author | L. C. Lee | |
| date accessioned | 2017-05-08T23:47:47Z | |
| date available | 2017-05-08T23:47:47Z | |
| date copyright | May, 1995 | |
| date issued | 1995 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27778#266_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/115639 | |
| description abstract | A slip-line field model is presented for the determination of the chip curl radius when cutting with a grooved restricted contact tool. The calculated values are found to provide a good approximation, especially for larger uncut chip thicknesses. The calculated results are consistently lower than the measured ones due to the elastic recovery of the chip after leaving the groove. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | A Slip-Line Field Model for the Determination of Chip Curl Radius | |
| type | Journal Paper | |
| journal volume | 117 | |
| journal issue | 2 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.2803312 | |
| journal fristpage | 266 | |
| journal lastpage | 271 | |
| identifier eissn | 1528-8935 | |
| keywords | Approximation AND Cutting | |
| tree | Journal of Manufacturing Science and Engineering:;1995:;volume( 117 ):;issue: 002 | |
| contenttype | Fulltext | |
