| contributor author | T. Tabata | |
| contributor author | S. Masaki | |
| date accessioned | 2017-05-08T23:35:59Z | |
| date available | 2017-05-08T23:35:59Z | |
| date copyright | November, 1991 | |
| date issued | 1991 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27753#446_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/108795 | |
| description abstract | An experimental set-up for cold butt welding is developed. Before conventional upsetting of two specimens to be bonded, surfaces of the specimens are shaved off by an edge to bring out the virgin metal which is essential to cold pressure welding. Since the bulk deformation to form the virgin surfaces is smaller compared with the conventional process without using the edge, complete bonding is accomplished with a small strain in upsetting of the specimens. This result leads the following advantages of the present process. (1) Waste of the material which is used as a flash is reduced. (2) The upsetting load, i.e., the bonding load is lower. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | A New Process of Cold Butt Welding | |
| type | Journal Paper | |
| journal volume | 113 | |
| journal issue | 4 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.2899721 | |
| journal fristpage | 446 | |
| journal lastpage | 449 | |
| identifier eissn | 1528-8935 | |
| keywords | Butt welding | |
| keywords | Bonding | |
| keywords | Stress | |
| keywords | Pressure | |
| keywords | Deformation | |
| keywords | Metals AND Welding | |
| tree | Journal of Manufacturing Science and Engineering:;1991:;volume( 113 ):;issue: 004 | |
| contenttype | Fulltext | |
