Abstract: Analytic bounds for and properties of the pressure field in the finite and infinite gas-lubricated slider bearing are derived without resorting to numerical or asymptotic approximations. For ...

Abstract: The hydrogen bubble technique for flow visualization is modified for quantitative determination of velocity of water flowing in clear plastic tubes. Calibration tests are reported showing the ...

Abstract: The effect of stream cross‐sectional geometry and hydraulic roughness data errors on the accuracy of computed steady‐flow water surface profiles is reported. Stream cross‐sectional geometry may be developed by several ...

Abstract: The potential for increasing the energy output of existing hydroelectric plants was investigated on a national scale. Analysis was performed on 1,288 sites (the complete inventory) for increases through enlarging powerhouses, ...

Abstract: The objective of this work is to provide a preliminary screening of the effectiveness of alternative sorbents for treating ground water contaminated with methyl tert-butyl ether (MTBE). Sorbents studied include synthetic ...

Abstract: A study investigating the modal properties and dynamic response of several laboratory-constructed and in situ floors supported with cold-formed steel C-shaped joists for floors was conducted. The tested floors were typical ...

Abstract: Aluminum alloys are used in a variety of structural engineering applications, such as transportable and lightweight bridges, due to their high strength-to-weight ratio and durability. However, the heat of welding may reduce ...

Abstract: An investigation of the transient character of the near-field acoustic radiation from a water hammer excited, cylindrical diaphragm was conducted. The investigation was principally experimental and ...