Abstract: Selection of cutter diameter and position of the cutter with reference to the work piece was studied to control the face-milling tool tip failure by fracture. The majority of the tests consisted ...

Abstract: A new method of making wire is discussed in which cutting and forming are combined into one process. A chip is first obtained by cutting a billet using a specially designed cutting tool. ...

Abstract: When an indenter is pressed into a surface as in a hardness test, the material beneath the indenter undergoes plastic flow. When the load is removed from the indenter, a second plastic flow ...

Abstract: Performance data were obtained for tungsten carbide, titanium carbide, and oxide tools in the finish turning of C-30 gray iron. Characteristics of typical wear patterns were examined in relation ...