Search
CSV
RISDynamic Features of a Planetary Gear System With Tooth Crack Under Different Sizes and Inclination Angles
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Planetary gears are widely used in the industry due to their advantages of compactness, high powertoweight ratios, high efficiency, and so on. However, planetary gears such as that in wind turbine transmissions always ...
An Analytical Dynamic Model of a Hollow Cylindrical Roller Bearing
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Hollow cylindrical roller bearings (HCRBs) have obtained much attention from design engineers in bearing industries since they can perform better than solid cylindrical roller bearings (SCRBs) in centrifugal forces, contact ...
A New Model for the Relationship Between Vibration Characteristics Caused by the Time Varying Contact Stiffness of a Deep Groove Ball Bearing and Defect Sizes
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Vibration characteristics of a deep groove ball bearing caused by a localized surface defect are greatly affected by defect sizes, such as the length, width, and depth. However, effects of the defect depth, the timevarying ...
Configuration Design of Dual-Input Compound Power-Split Mechanism for In-Wheel Motor-Driven Electrical Vehicles Based on an Improved Lever Analogy Method
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: High power density in-wheel motor could be achieved by integrating a high-speed ratio (larger than 25) compound power-split mechanism (CPSM) with small motors. However, due to the exhaustive searching method adopted by the ...
Optimization of Co Firing Burners
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: At present, unless a boiler is especially designed to burn biomass, the levels of cofiring are generally limited to around 5% by mass. Higher levels of substitution sometimes lead to burner instability and other issues. ...