Abstract: A point heat source model is employed to study the thermal wake function for an array of rectangular electronic modules situated in a uniform flow stream. For the particular case of in-line ...

Abstract: A pin fin with variable fin base thickness is optimized using a two-dimensional analytic method. The values of the inner wall temperature and fin volume are given as constants. The fin base ...

Abstract: Experimental results from a study of the three-dimensional flow in a linear compressor cascade with stationary endwall at design conditions are presented for tip clearance levels of 1.0, 2.0, ...

Abstract: An analysis of the experimental data of a linear compressor cascade with tip clearance is presented with special attention to the development of the tip leakage vortex. A method for determining ...

Abstract: Tip leakage flow in a linear compressor cascade of NACA 65-1810 profiles is investigated, for tip clearance levels of 1.0, 2.0, and 3.25 percent of chord at design and off-design flow conditions. ...

Abstract: A Navier–Stokes solver is applied to investigate the three-dimensional viscous flow in a low-speed linear compressor cascade with tip clearance at design and off-design conditions with two different ...

Abstract: A new modal identification method for Conservative Nongyroscopic Systems is proposed. The modal identification method is formulated as a variational problem in which stationary values of a ...

Abstract: This paper studies discrete time noncollocated control of flexible mechanical systems. A sampled data system with one sensor and one actuator is formulated. Specific time delay is introduced in ...