Search
CSV
RISDiscussion: “Measured Passage Velocities in a Radial Impeller With Shrouded and Unshrouded Configurations” (Howard, J. H. G., and Kittmer, C. W., 1975, ASME J. Eng. Power, 97, pp. 207–212)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Measurement of Two-Dimensional Periodic Flow With a Cobra Probe” (Senoo, Y., Kita, Y., and Ookuma, K., 1973, ASME J. Fluids Eng., 95, pp. 295–299)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “An Experimental Investigation of Incompressible Channel Flow Near Transition” (Feliss, N. A., Potter, M. C., and Smith, M. C., 1977, ASME J. Fluids Eng., 99, pp. 693–698)
Publisher: The American Society of Mechanical Engineers (ASME)
Further Data on the Pressure Recovery Performance of Straight-Channel, Plane-Divergence Diffusers at High Subsonic Mach Numbers
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Measurements are reported of the pressure recovery of straight-channel, symmetric, single-plane-divergence diffusers with inlet Mach numbers between 0.2 and choking for an aspect ratio of 5.0. The ...
First-Order Pump Surge Behavior
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents the results of an empirical study undertaken to assess the appropriateness and applicability of a simple, analytical model of pump-piping system flow instability. The analysis ...
Effect of Specific Heat Ratio, Impeller Tip Running Clearance, and Compressor Insulation on High-Pressure-Ratio Centrifugal Compressor Modeling
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Results are displayed which show the effect of gas specific heat ratio, impeller tip running clearance, and compressor insulation on modeling of a high-pressure-ratio compressor’s performance. The ...
Discussion: “Velocity and Temperature Fluctuation Measurements in a Turbulent Boundary Layer Downstream of a Stepwise Discontinuity in Wall Temperature” (Johnson, D. S., 1959, ASME J. Appl. Mech., 26, pp. 325–336)
Publisher: The American Society of Mechanical Engineers (ASME)
Straight Channel Diffuser Performance at High Inlet Mach Numbers
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Measurements have been made of the pressure recovery of straight wall, single plane divergence diffusers with inlet Mach numbers between 0.2 and choking (0.2 ≤ Mt < 1.0). In contrast to ...
An Experimental Study of Surge in Centrifugal Compressors
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Results of high-response measurements in a high-pressure-ratio centrifugal compressor during surge operation are presented. The interpretation of the data provides improved understanding of the flow ...
Use of Hydrogen Bubbles for Quantitative Determination of Time-Dependent Velocity Fields in Low-Speed Water Flows
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Improved flow-visualization methods based on the hydrogen-bubble technique are described. Use of “combined-time-streak markers” allows quantitative measurement of the instantaneous velocity field in ...