Search
CSV
RISTensile Flow Behavior of 9Cr–2WVTa Reduced Activation Ferritic/Martensitic Steel
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Tensile flow behavior of 9Cr–2WVTa ferritic/martensitic (RAFM) steel in normalizedtempered condition has been studied based on Voce equation over the temperature range of 25–600 آ°C. Yield strength (YS) and ultimate ...
The Effect of Using Different Wake Models on Wind Farm Layout Optimization: A Comparative Study
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The accuracy of analytical wake models applied in wind farm layout optimization (WFLO) problems is of great significance as the high-fidelity methods such as large eddy simulation (LES) and Reynolds-averaged Navier–Stokes ...
Genetic Algorithm as the Solution of Non-Linear Inverse Heat Conduction Problems: A Novel Sequential Approach
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Direct measurement of surface heat flux could be extremely challenging, if not impossible, in numerous applications. In such cases, the use of temperature measurement data from subsurface locations can facilitate the ...
Special Issue: First James V. Beck Memorial Symposium on Inverse Problems, Parameter Estimation, and Heat Conduction
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The James V. Beck Memorial Symposium at the ASME Summer Heat Transfer Conference (SHTC) provides a platform for researchers to exchange ideas, showcase research achievements, and discuss new developments in the areas of ...
Modeling and Analysis of a Combined Photovoltaic Thermoelectric Power Generation System
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In the present paper, the possibility of using thermoelectric power generator modules (TEGs) to convert the heat generated by the photovoltaic/thermal (PVT) collector into electricity is investigated. A comprehensive heat ...
Energy Efficiency Improvement in K-12 Schools: A Case Study in Florida
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: K-12 schools are responsible for over 1.4% of the total annual energy consumption in the United States. In a collaboration between Florida Institute of Technology and Brevard Public Schools (BPS), three schools are identified ...
Estimation of Multiple Contact Conductances in a Silicon-Indium-Silicon Stack
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This report documents evaluation of simultaneous estimation of multiple interfacial heat transfer coefficients (HTCs) using transient measurements from an experiment designed for steady-state operation. The design of a ...
Construction of Short-Time Heat Conduction Solutions in One-Dimensional Finite Rectangular Bodies
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The concept of both penetration and deviation times for rectangular coordinates along with the principle of superposition for linear problems allows short-time solutions to be constructed for a one-dimensional (1D) rectangular ...
Effect of Pin and Shoulder Geometry on Stir Zone and Mechanical Properties of Friction Stir Spot Welded Aluminum Alloy 2024 T3 Sheets
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Friction stir spot welding (FSSW) was performed on 2024T3 Al alloy to study the effect of pin and shoulder geometry (cylindrical and triangular shapes) on stir zone (SZ) characteristics and mechanical properties of welded ...
Neural NetworkBased Building Energy Models for Adapting to PostOccupancy Conditions: A Case Study for Florida
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Building energy models (BEMs) are usually developed by subject matter experts during the design phase to help with decision making for achieving a more energyefficient design at a minimum cost. The energy performance of a ...