Search
CSV
RISHeat Transfer and Pressure Drop Measurements in a Rib Roughened Leading Edge Cooling Channel
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In order to enhance convective heat transfer in internal cooling channels, ribs are often used to manipulate the flow field and to benefit from their effect on thermal performance. This paper ...
An Experimental and Numerical Study of Heat Transfer and Pressure Loss in a Rectangular Channel With V-Shaped Ribs
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: An experimental and numerical study was conducted to determine the thermal performance of V-shaped ribs in a rectangular channel with an aspect ratio of 2:1. Local heat transfer coefficients ...
Heat Transfer Characteristics of an Oblique Jet Impingement Configuration in a Passage With Ribbed Surfaces
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Heat transfer measurements of a confined impingement cooling configuration with ribs on the target surfaces are presented. The assembly consists of four nonperpendicular walls of which one holds ...
Time-Resolved Heat Transfer Measurements on the Tip Wall of a Ribbed Channel Using a Novel Heat Flux Sensor—Part I: Sensor and Benchmarks
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A novel heat flux sensor was tested that allows for time-resolved heat flux measurements in internal ribbed channels related to the study of passages in gas turbine blades. The working principle ...
The Effect of Side Wall Mass Extraction on Pressure Loss and Heat Transfer of a Ribbed Rectangular Two-Pass Internal Cooling Channel
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Gas turbine blades are often cooled by using combined internal and external cooling methods where for internal cooling purposes, usually, serpentine passages are applied. In order to optimize ...
The Effect of Turning Vanes on Pressure Loss and Heat Transfer of a Ribbed Rectangular Two-Pass Internal Cooling Channel
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Gas turbine blades are usually cooled by using ribbed serpentine internal cooling passages, which are fed by extracted compressor air. The individual straight ducts are connected by sharp 180 ...
Time-Resolved Heat Transfer Measurements on the Tip Wall of a Ribbed Channel Using a Novel Heat Flux Sensor—Part II: Heat Transfer Results
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Measurements using a novel heat flux sensor were performed in an internal ribbed channel representing the internal cooling passages of a gas turbine blade. These measurements allowed for the ...
Validation and Analysis of Numerical Results for a Varying Aspect Ratio Two-Pass Internal Cooling Channel
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Numerical results for an internal ribbed cooling channel including a 180 deg bend with a 2:1 inlet and a 1:1 aspect ratio outlet channel were validated against experimental results in terms ...
Computational Fluid Dynamics Simulations of Flow and Heat Transfer in a Preswirl System: Influence of Rotating-Stationary Domain Interface
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents computational fluid dynamics (CFD) predictions of flow and heat transfer for an over-swirled low-radius preswirl system and comparison with experimental data. The rotor-stator ...