Search
Now showing items 1-10 of 83
OTEC Gas Desorption Studies
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Seawater deaeration is a process affecting almost all proposed ocean thermal energy conversion (OTEC) open-cycle power systems. If the noncondensible dissolved air is not removed from a power ...
High and Low-Cycle Fatigue Damage Evaluation of Multilayer Thin Film Structure
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A five-layered (Cu/Cr/Kapton® /Cr/Cu) metallic thin film structure was subjected to a completely reversed bending fatigue cycling with a wide ranges of applied strain amplitudes from 0.25 ...
An Intelligent Approach to Multiple Cutters of Maximum Sizes for Three-Axis Milling of Sculptured Surface Parts
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Due to their complex geometries, sculptured surface parts should be machined with multiple cutters of optimal sizes for high quality and productivity. Current methods of determining cutter sizes, ...
An Efficient, Accurate Approach to Representing Cutter-Swept Envelopes and Its Applications to Three-Axis Virtual Milling of Sculptured Surfaces
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: To address a major technical challenge in simulating geometric models of machined sculptured surfaces in three-axis virtual machining, this paper presents an efficient, accurate approach to ...
Modeling Trip Generation with Data from Single and Two Independent Cross-Sectional Travel Surveys
Publisher: American Society of Civil Engineers
Abstract: This paper investigates the possibility of developing trip generation models using data collected at two or more points in time in independent cross-sectional travel surveys conducted in the same urban area. Alternative ...
Cost Optimization of Nanofiltration with Fouling by Natural Organic Matter
Publisher: American Society of Civil Engineers
Abstract: An artificial neural network and genetic algorithm routine has been developed for predicting and optimizing membrane system performance. The model predicted system behavior in response to operating conditions of applied ...
Dynamic Stability of Isotropic or Composite-Material Cylindrical Shells Containing Swirling Fluid Flow
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A linear stability analysis is presented for a thin-walled, circular cylindrical shell of orthotropic material conveying a swirling flow. Shell motion is modeled by using the dynamic orthotropic ...
Vibration Control of the Elastodynamic Response of High-Speed Flexible Linkage Mechanisms
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A methodology for suppressing the elastodynamic responses of high-speed flexible linkage mechanisms by employing a state feedback optimal control scheme is proposed. This permits the mechanisms ...
Criteria for Analysis-Test Correlation of Structural Dynamic Systems
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A rational criterion for structural dynamic analysis-test correlation has been established by using a matrix perturbation technique. This criterion can be used for the verification of an analytical ...
Impedance Control for a Golf Swing Robot to Emulate Different-Arm-Mass Golfers
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Various golfers can play different golf swing motions even if they hold the same golf club. This phenomenon casts light on the significance of the dynamic interaction between the golfer’s arm ...
CSV
RIS