Removal of Dissolved- and Free-Phase Benzene Pools from Ground Water Using In Situ Air Sparging

Abstract

This paper presents the results of a laboratory investigation performed to study the use of air sparging to remediate dissolved-phase and free-phase [or non-aqueous-phase liquid (NAPL)-phase] benzene pools from ground water. The specific objectives of the study were (1) to assess how air injection rate affects the mass transfer and transport of dissolved- and NAPL-phase pools; and (2) to determine the effect of ground-water flow on the removal of dissolved- and NAPL-phase pools during the application of air sparging. A total of five 2D physical model tests were performed in a homogeneous coarse sand profile subjected to both static ground water and ground-water flow conditions. Three different air injection rates were used in a static ground-water condition, and two different air flow rates were used in soil profiles subjected to ground-water flow (hydraulic gradient = 0.011). All tests were performed with similar initial dissolved- and NAPL-phase benzene conditions. Injected air traveled within a parabolic zone of influence (in channel mode) when subjected to both static ground water and ground-water flow conditions, indicating that ground-water flow (for the ground-water velocities tested) did not affect the injected air zone of influence. An increase in air injection rate led to faster contaminant removal; however, at higher air injection rates, a threshold rate of removal was reached above which further increases in injection rate are a waste of effort. Additionally, air injected into the soil profile reduced the hydraulic conductivity within the zone of influence. This in turn led to lower ground-water flow rates, allowing for effective interception and treatment of a migrating NAPL plume. Higher air injection rates led to further reductions in hydraulic conductivity, allowing for substantial control of the NAPL plume in the downgradient direction. Overall, this study showed that air sparging can be used to effectively remediate dissolved- and NAPL-phase benzene.