YaBeSH Engineering and Technology Library

    • Journals
    • PaperQuest
    • YSE Standards
    • YaBeSH
    • Login
    View Item 
    •   YE&T Library
    • ASCE
    • Journal of Aerospace Engineering
    • View Item
    •   YE&T Library
    • ASCE
    • Journal of Aerospace Engineering
    • View Item
    • All Fields
    • Source Title
    • Year
    • Publisher
    • Title
    • Subject
    • Author
    • DOI
    • ISBN
    Advanced Search
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Archive

    Experimental Investigation of Flow Control on a High-Lift Wing Using Modulated Pulse Jet Vortex Generator

    Source: Journal of Aerospace Engineering:;2022:;Volume ( 035 ):;issue: 005::page 05022001
    Author:
    Soheila Abdolahipour
    ,
    Mahmoud Mani
    ,
    Arash Shams Taleghani
    DOI: 10.1061/(ASCE)AS.1943-5525.0001463
    Publisher: ASCE
    Abstract: In this paper, the potential of a novel active flow control strategy by means of a modulated pulse jet vortex generator to enhance high-lift performance is demonstrated on a two-dimensional supercritical National Aeronautics and Space Administration (NASA) SC(2)-0714 airfoil with a single slotted trailing-edge flap at a high deflection angle. Fast-switching solenoid valves and compressed air were used as actuators to excite the flow. The vortex generator slot pairs were incorporated into the shoulder of the trailing-edge flap, where the flow separation occurs due to the high flow deflection and severe adverse pressure gradient. In these experiments, in addition to the simple square-wave excitation signal, a burst-modulated excitation signal as a novel pulse jet sequence was implemented to produce the unsteady blowing. The burst-modulation signal was used for the first time for a fast-switching solenoid valve actuator. The experiments were performed at a freestream velocity of 25  m/s with a corresponding Reynolds number of about 1×106 for a range of angles of attack from 0° to 20° at flap deflection angles from 0° to 35°. The results indicated that the ejection from vortex generator slot pairs was able to prevent flow separation completely in most conditions. These measurements revealed that the burst-modulated excitation was accompanied by more aerodynamic improvements and less air consumption relative to the simple pulsed jet excitation. In the best flow control mode, the results showed about a 12.6% increase in the lift coefficient and a 19.8% decrease in the drag coefficient.
    • Download: (1.729Mb)
    • Show Full MetaData Hide Full MetaData
    • Get RIS
    • Item Order
    • Go To Publisher
    • Statistics

      Experimental Investigation of Flow Control on a High-Lift Wing Using Modulated Pulse Jet Vortex Generator

    URI
    https://yetl.yabesh.ir/yetl1/handle/yetl/4286376
    Collections
    • Journal of Aerospace Engineering

    Show full item record

    contributor authorSoheila Abdolahipour
    contributor authorMahmoud Mani
    contributor authorArash Shams Taleghani
    date accessioned2022-08-18T12:17:51Z
    date available2022-08-18T12:17:51Z
    date issued2022/07/13
    identifier other%28ASCE%29AS.1943-5525.0001463.pdf
    identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4286376
    description abstractIn this paper, the potential of a novel active flow control strategy by means of a modulated pulse jet vortex generator to enhance high-lift performance is demonstrated on a two-dimensional supercritical National Aeronautics and Space Administration (NASA) SC(2)-0714 airfoil with a single slotted trailing-edge flap at a high deflection angle. Fast-switching solenoid valves and compressed air were used as actuators to excite the flow. The vortex generator slot pairs were incorporated into the shoulder of the trailing-edge flap, where the flow separation occurs due to the high flow deflection and severe adverse pressure gradient. In these experiments, in addition to the simple square-wave excitation signal, a burst-modulated excitation signal as a novel pulse jet sequence was implemented to produce the unsteady blowing. The burst-modulation signal was used for the first time for a fast-switching solenoid valve actuator. The experiments were performed at a freestream velocity of 25  m/s with a corresponding Reynolds number of about 1×106 for a range of angles of attack from 0° to 20° at flap deflection angles from 0° to 35°. The results indicated that the ejection from vortex generator slot pairs was able to prevent flow separation completely in most conditions. These measurements revealed that the burst-modulated excitation was accompanied by more aerodynamic improvements and less air consumption relative to the simple pulsed jet excitation. In the best flow control mode, the results showed about a 12.6% increase in the lift coefficient and a 19.8% decrease in the drag coefficient.
    publisherASCE
    titleExperimental Investigation of Flow Control on a High-Lift Wing Using Modulated Pulse Jet Vortex Generator
    typeJournal Article
    journal volume35
    journal issue5
    journal titleJournal of Aerospace Engineering
    identifier doi10.1061/(ASCE)AS.1943-5525.0001463
    journal fristpage05022001
    journal lastpage05022001-18
    page18
    treeJournal of Aerospace Engineering:;2022:;Volume ( 035 ):;issue: 005
    contenttypeFulltext
    DSpace software copyright © 2002-2015  DuraSpace
    نرم افزار کتابخانه دیجیتال "دی اسپیس" فارسی شده توسط یابش برای کتابخانه های ایرانی | تماس با یابش
    yabeshDSpacePersian
     
    DSpace software copyright © 2002-2015  DuraSpace
    نرم افزار کتابخانه دیجیتال "دی اسپیس" فارسی شده توسط یابش برای کتابخانه های ایرانی | تماس با یابش
    yabeshDSpacePersian