Influence of Microroughness on the Frictional Behavior and Wear Response of Planar Saw-Cut Rock Surfaces

Abstract

Saw-cut rock surfaces, classically utilized to estimate basic friction angle of discontinuities by means of tilt test and other procedures, may seem planar to the naked eye. Nevertheless, they actually present roughness at a micrometric scale. Aiming at characterizing some of these saw-cut rock surfaces and assessing the possible implications between their microscale topography and the resulting tribological behavior, the authors of this study resorted to the 3D focus-variation technique to analyze different surface-texture parameters. Tilt tests were carried out on specimens cut on three rock types, and the involved sliding surfaces were evaluated at a microscale for different testing stages (prior to any test and after two series of repeated tests). An apparently logical inverse correlation between repeated testing and friction angle has been observed, more marked for the smoother surfaces. Higher roughness at the scale of the analysis tends to produce lower friction-angle values, as otherwise observed for mismatched natural rock surfaces. In addition, saw-cut rock surfaces present systematically negative skewness and high values of kurtosis for their height distributions, indicating the occurrence of narrow and deep pits or valleys. Directional hybrid parameters and, in particular, the root mean square (RMS) of the gradient of the surface in the direction of sliding correlates rather well with the measured sliding angle. The authors concluded that the 3D focus-variation technique represents a powerful tool to assess surface-texture parameters of saw-cut rock surfaces, in addition to being useful for understanding some features of the tribological, or wear and frictional, behavior of these type of surfaces.