YaBeSH Engineering and Technology Library

    • Journals
    • PaperQuest
    • YSE Standards
    • YaBeSH
    • Login
    View Item 
    •   YE&T Library
    • ASME
    • Journal of Solar Energy Engineering
    • View Item
    •   YE&T Library
    • ASME
    • Journal of Solar Energy Engineering
    • View Item
    • All Fields
    • Source Title
    • Year
    • Publisher
    • Title
    • Subject
    • Author
    • DOI
    • ISBN
    Advanced Search
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Archive

    Experimental Investigation of Thermal Performance of a Multipurpose PV Solar Collector Wall With Phase Change Material

    Source: Journal of Solar Energy Engineering:;2019:;volume( 141 ):;issue: 006::page 64501
    Author:
    Chantawong, Preeda
    DOI: 10.1115/1.4043712
    Publisher: American Society of Mechanical Engineers (ASME)
    Abstract: The author reports an experimental investigation of the thermal performance of a multipurpose photovoltanic (PV) solar wall with phase change material (PVSW-PCM). The PVSW-PCM configuration was made of double layers. The external layer consists of a 12 Wp photovoltaic panel attached to a 15 cm thick PCM tank integrating water pipes. The internal wall is an ordinary clear glass pane. There is an 8 cm air gap between the two layers. The PVSW-PCM was integrated into the southern side of a small house of 4.05 m3 volume built by autoclaved aerated concrete block walls 0.07 m thick. On top of the external layer, three glass blocks (3 × 0.2 × 0.2 cm2) are installed to ensure indoor illumination. The absorbed solar radiation by the PV panel and PCM heats the water in the pipes and the air in the gap. The hot water produced is stored in a 10 liters tank located near the roof. At the inner lower part (room side) and the external upper part (ambient) of the gap, a small DC fan (12 V, 0.48 A) box was installed. The fans were connected to the PV panel directly to enhance indoor ventilation. The investigation considered both natural (fans OFF) and PV assisted ventilation. Another similar house without the PVSW-PCM referred to as glass wall (GW) was built and used as a reference for comparison. The experimental results revealed that the indoor temperature of the PVSW-PCM house was considerably lower than that of the GW house. Moreover, the PVSW-PCM could produce hot water temperature of 55–62 °C and induce a ventilation rate proportional to the intensity of solar radiation. Indoor illumination was sufficient for general house use. Therefore, the PVSW-PCM offers a new alternative for architects and engineers to reduce electric energy use for producing hot water and ventilation and save electrical energy consumption of air conditioner, as the indoor temperature is lower than that of the conventional house.
    • Download: (645.6Kb)
    • Show Full MetaData Hide Full MetaData
    • Get RIS
    • Item Order
    • Go To Publisher
    • Statistics

      Experimental Investigation of Thermal Performance of a Multipurpose PV Solar Collector Wall With Phase Change Material

    URI
    https://yetl.yabesh.ir/yetl1/handle/yetl/4258004
    Collections
    • Journal of Solar Energy Engineering

    Show full item record

    contributor authorChantawong, Preeda
    date accessioned2019-09-18T09:01:34Z
    date available2019-09-18T09:01:34Z
    date copyright5/28/2019 12:00:00 AM
    date issued2019
    identifier issn0199-6231
    identifier othersol_141_6_064501
    identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4258004
    description abstractThe author reports an experimental investigation of the thermal performance of a multipurpose photovoltanic (PV) solar wall with phase change material (PVSW-PCM). The PVSW-PCM configuration was made of double layers. The external layer consists of a 12 Wp photovoltaic panel attached to a 15 cm thick PCM tank integrating water pipes. The internal wall is an ordinary clear glass pane. There is an 8 cm air gap between the two layers. The PVSW-PCM was integrated into the southern side of a small house of 4.05 m3 volume built by autoclaved aerated concrete block walls 0.07 m thick. On top of the external layer, three glass blocks (3 × 0.2 × 0.2 cm2) are installed to ensure indoor illumination. The absorbed solar radiation by the PV panel and PCM heats the water in the pipes and the air in the gap. The hot water produced is stored in a 10 liters tank located near the roof. At the inner lower part (room side) and the external upper part (ambient) of the gap, a small DC fan (12 V, 0.48 A) box was installed. The fans were connected to the PV panel directly to enhance indoor ventilation. The investigation considered both natural (fans OFF) and PV assisted ventilation. Another similar house without the PVSW-PCM referred to as glass wall (GW) was built and used as a reference for comparison. The experimental results revealed that the indoor temperature of the PVSW-PCM house was considerably lower than that of the GW house. Moreover, the PVSW-PCM could produce hot water temperature of 55–62 °C and induce a ventilation rate proportional to the intensity of solar radiation. Indoor illumination was sufficient for general house use. Therefore, the PVSW-PCM offers a new alternative for architects and engineers to reduce electric energy use for producing hot water and ventilation and save electrical energy consumption of air conditioner, as the indoor temperature is lower than that of the conventional house.
    publisherAmerican Society of Mechanical Engineers (ASME)
    titleExperimental Investigation of Thermal Performance of a Multipurpose PV Solar Collector Wall With Phase Change Material
    typeJournal Paper
    journal volume141
    journal issue6
    journal titleJournal of Solar Energy Engineering
    identifier doi10.1115/1.4043712
    journal fristpage64501
    journal lastpage064501-7
    treeJournal of Solar Energy Engineering:;2019:;volume( 141 ):;issue: 006
    contenttypeFulltext
    DSpace software copyright © 2002-2015  DuraSpace
    نرم افزار کتابخانه دیجیتال "دی اسپیس" فارسی شده توسط یابش برای کتابخانه های ایرانی | تماس با یابش
    yabeshDSpacePersian
     
    DSpace software copyright © 2002-2015  DuraSpace
    نرم افزار کتابخانه دیجیتال "دی اسپیس" فارسی شده توسط یابش برای کتابخانه های ایرانی | تماس با یابش
    yabeshDSpacePersian