Journal of Fluids Engineering: Recent submissions
Now showing items 7361-7380 of 9024
-
Measurements of Apparent Mass Torque Coefficients of Two-Dimensional Centrifugal Impellers
(The American Society of Mechanical Engineers (ASME), 1986)Apparent mass torque coefficients for fluctuations of flow rate and angular velocity are determined experimentally for two-dimensional centrifugal impellers. Nearly sinusoidal fluctuations of flow ... -
Discussion: “Theory for Supercavitating Flow Through an Arbitrary Form Hydrofoil” (Ōba, R., 1964, ASME J. Basic Eng., 86, pp. 285–290)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “Effect of Surface Energy on the Wear Process” (Rabinowicz, E., and Foster, R. G., 1964, ASME J. Basic Eng., 86, pp. 306–310)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “Experimental Investigations of Incipient and Desinent Cavitation” (Lehman, A. F., and Young, J. O., 1964, ASME J. Basic Eng., 86, pp. 275–281)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “A Visual and Photographic Study of the Inception of Vaporization in Adiabatic Flow” (Mikol, E. P., and Dudley, J. C., 1964, ASME J. Basic Eng., 86, pp. 257–261)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “Expansion of a Very Low Quality Two-Phase Fluid Through a Convergent-Divergent Nozzle” (Starkman, E. S., Schrock, V. E., Neusen, K. F., and Maneely, D. J., 1964, ASME J. Basic Eng., 86, pp. 247–254)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “On the Separation, Reattachment, and Redevelopment of Incompressible Turbulent Shear Flow” (Mueller, T. J., Korst, H. H., and Chow, W. L., 1964, ASME J. Basic Eng., 86, pp. 221–225)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “Poppet Valve Stability” (Funk, James E., 1964, ASME J. Basic Eng., 86, pp. 207–212)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “Supercavitating Foils With Flaps Beneath a Free Surface” (Auslaender, J., 1964, ASME J. Basic Eng., 86, pp. 197–204)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “A Review on Vortex Streets, Periodic Wakes, and Induced Vibration Phenomena” (Marris, A. W., 1964, ASME J. Basic Eng., 86, pp. 185–193)
(The American Society of Mechanical Engineers (ASME), 1964) -
Discussion: “Computation of the Critical Flow Function, Pressure Ratio, and Temperature Ratio for Real Air” (Reimer, Robert M., 1964, ASME J. Basic Eng., 86, pp. 169–173)
(The American Society of Mechanical Engineers (ASME), 1964) -
Note on the Sealing of Large Bore Pressure Vessels
(The American Society of Mechanical Engineers (ASME), 1964) -
Friction Factors for Fully Developed Turbulent Flow in Ducts With and Without Heat Transfer
(The American Society of Mechanical Engineers (ASME), 1964)Tests were performed with water flowing vertically upward through a 0.087-in. × 1-in. × 27-in. long rectangular channel to determine friction factors with and without heat transfer. The ... -
Pressure Drop Due to the Entrance Region in Ducts of Arbitrary Cross Section
(The American Society of Mechanical Engineers (ASME), 1964)A general analytical method has been devised for determining the pressure drop due to flow development in the entrance region of ducts of arbitrary cross section. The essential feature of the ... -
Steady Fluid Flow in a Radial Vaneless Diffuser
(The American Society of Mechanical Engineers (ASME), 1964)The performance of a centrifugal pump or compressor system has often been investigated on an overall basis for a wide range of operations and these investigations have, in the past, resulted ... -
The Nature of Self-Excitation in the Flow-Induced Vibration of Flat Plates
(The American Society of Mechanical Engineers (ASME), 1964)Flow-induced vibrations of flat plates are studied in water. An equation of motion of the plate-spring system is formulated incorporating the hydrodynamic loads given by the linearized potential ... -
Dynamic Response of Fluid Lines
(The American Society of Mechanical Engineers (ASME), 1964)The use of hydraulic transmission lines in automatic control, liquid-propellant rocket, and other systems requires accurate knowledge of their dynamic response. In this paper the effects of fluid ... -
Rigid Water-Column Theory in Water-Hammer Problems
(The American Society of Mechanical Engineers (ASME), 1964)Equations and charts for solving pressure-rise problems by the rigid water-column theory are presented with an example of their application. These are compared with the elastic water-column theory ... -
Two-Phase Flow in Capillary Tubes
(The American Society of Mechanical Engineers (ASME), 1964)The adiabatic flow of two phases, gas and liquid, has been studied in horizontal tubes of capillary diameter. The flow has been studied primarily in the regime where the gas flows as long ... -
Symmetric, Rotational, Supercavitating Flow About a Slender Wedge
(The American Society of Mechanical Engineers (ASME), 1964)Two approximations to the linearized theory for supercavitating flow about slender bodies are applied to the case of a symmetric, rotational flow about a slender wedge. Both approximations produce ...