| contributor author | G. W. Maurer | |
| contributor author | B. W. LeTourneau | |
| date accessioned | 2017-05-08T23:22:28Z | |
| date available | 2017-05-08T23:22:28Z | |
| date copyright | September, 1964 | |
| date issued | 1964 | |
| identifier issn | 0098-2202 | |
| identifier other | JFEGA4-27255#627_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/101134 | |
| description abstract | Tests were performed with water flowing vertically upward through a 0.087-in. × 1-in. × 27-in. long rectangular channel to determine friction factors with and without heat transfer. The following range of variables was covered: Mass velocities: 0.60 × 106 to 4.0 × 106 lbm /hr-ft2 ; Heat flux: 0 to 1.6 × 106 Btu/hr-ft2 ; Inlet temperature: 59 to 510 deg F; Pressures: 300 to 2000 psia. The isothermal data confirmed the use of the hydraulic equivalent diameter with the conventional circular tube friction factors for narrow rectangular channels at Reynolds numbers from 4 × 103 to 5 × 105 . Using the results of the heated tests and the data existing in the literature, a general correlation was formulated which correlated the data for both water and air. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Friction Factors for Fully Developed Turbulent Flow in Ducts With and Without Heat Transfer | |
| type | Journal Paper | |
| journal volume | 86 | |
| journal issue | 3 | |
| journal title | Journal of Fluids Engineering | |
| identifier doi | 10.1115/1.3653187 | |
| journal fristpage | 627 | |
| journal lastpage | 636 | |
| identifier eissn | 1528-901X | |
| keywords | Friction | |
| keywords | Heat transfer | |
| keywords | Fully developed turbulent flow | |
| keywords | Ducts | |
| keywords | Water | |
| keywords | Channels (Hydraulic engineering) | |
| keywords | Reynolds number | |
| keywords | Temperature AND Heat flux | |
| tree | Journal of Fluids Engineering:;1964:;volume( 086 ):;issue: 003 | |
| contenttype | Fulltext | |