Journal of Fluids Engineering: Recent submissions
Now showing items 7261-7280 of 9024
-
Theory for Supercavitating Flow Through an Arbitrary Form Hydrofoil
(The American Society of Mechanical Engineers (ASME), 1964)An accurate theory which included the following two methods was developed concerning the flow through an arbitrary form supercavitating hydrofoil: (i) A method by which to obtain the hydrofoil ... -
Experimental Investigations of Incipient and Desinent Cavitation
(The American Society of Mechanical Engineers (ASME), 1964)Experiments with water in a high speed recirculating water tunnel were undertaken to measure the pressures at which incipient and desinent cavitation occurred. Incipient cavitation is defined as ... -
Void Fraction Measurements in a Cavitating Venturi
(The American Society of Mechanical Engineers (ASME), 1964)A method is described for obtaining precise measurements of local density (or void fraction) in an axially symmetrical cavitating flow regime wherein a heavy fluid as mercury, molten lead, and ... -
A Visual and Photographic Study of the Inception of Vaporization in Adiabatic Flow
(The American Society of Mechanical Engineers (ASME), 1964)Data and observations obtained during the study of two-phase flow phenomena for refrigerants flowing in small bore copper and glass tubes have been examined for their significance to the ... -
Expansion of a Very Low Quality Two-Phase Fluid Through a Convergent-Divergent Nozzle
(The American Society of Mechanical Engineers (ASME), 1964)Flow in de Laval nozzles of high pressure, low-quality steam-water mixtures was investigated to determine the resulting mass flow rates and to acquire design criteria information. Qualities ranged ... -
The Problem of Pneumatic Pressure Lag: Part 2—Unsteady Flow in a Tubing System Closed at One End
(The American Society of Mechanical Engineers (ASME), 1964)The results of the steady-state analysis presented in Part 1 are applied to a quasi-steady analysis isothermal flow in constant diameter tubes (with straight-through unions at the extremities) ... -
The Problem of Pneumatic Pressure Lag: Part 1—Steady-State Flow in a Tubing System
(The American Society of Mechanical Engineers (ASME), 1964)An analytical and experimental investigation of the steady-state isothermal flow in a series system, comprised of a constant-diameter tube with reduced size unions located at the tube extremities, ... -
The Turbulent Flow at the Plane of Symmetry of a Collateral Three-Dimensional Boundary Layer
(The American Society of Mechanical Engineers (ASME), 1964)Momentum integral equations for the turbulent flow at the plane of symmetry of a three-dimensional boundary layer are rigorously derived. The use of orthogonol curvilinear coordinates allows a ... -
On the Separation, Reattachment, and Redevelopment of Incompressible Turbulent Shear Flow
(The American Society of Mechanical Engineers (ASME), 1964)An experimental and theoretical investigation is presented which describes the character of the mean motion and the structure of turbulence for the separation, reattachment, and redevelopment of ... -
Passage of a Turbulent Stream Through Honeycomb of Large Length-to-Diameter Ratio
(The American Society of Mechanical Engineers (ASME), 1964)An analysis is performed, similar to the classical one for screens, of the effect of a honeycomb on a turbulent stream, when the cell length is large enough to permit the flow to become ... -
Instabilities in the Flow of a Boiling Liquid
(The American Society of Mechanical Engineers (ASME), 1964)The time-varying flow of a boiling liquid through a series of ducts and heaters is considered for the case where the flow rate is controlled by a downstream orifice. It is shown that ... -
Poppet Valve Stability
(The American Society of Mechanical Engineers (ASME), 1964)The analysis presented in this paper shows that poppet valve instability can be caused by interaction of the fluid delivery line dynamics with those of the spring-mass of the valve. The ... -
Supercavitating Foils With Flaps Beneath a Free Surface
(The American Society of Mechanical Engineers (ASME), 1964)Linearized airfoil theory—in conjunction with a mapping technique—is applied to the calculation of the forces and moments acting on supercavitating hydrofoils operating near a free surface at ... -
The Dissipation Rate Correlation and Turbulent Secondary Flows in Noncircular Ducts
(The American Society of Mechanical Engineers (ASME), 1986) -
Discussion: “The Effect of Elbow Restraint on Pressure Transients” (Wiggert, D. C., Ortwell, R. S., and Hatfield, F. J., 1985, ASME J. Fluids Eng., 107, pp. 402–406)
(The American Society of Mechanical Engineers (ASME), 1986) -
Transition to Meandering Rivulet Flow in Vertical Parallel-Plate Channels
(The American Society of Mechanical Engineers (ASME), 1986) -
On the Fragmentation of Drops
(The American Society of Mechanical Engineers (ASME), 1986)Fragmentation of mercury drops falling through a bubbly aqueous liquid by a pressure shock wave was investigated by means of a shock tube capable of operating at driver pressures up to 3 ... -
A Review on Vortex Streets, Periodic Wakes, and Induced Vibration Phenomena
(The American Society of Mechanical Engineers (ASME), 1964)A survey is presented of recent experimental and theoretical researches on the problem of periodic wakes behind a cylinder in a stream. A synopsis is given of the present knowledge on the ... -
A Note on the Response Equations for Hot-Wire Anemometry
(The American Society of Mechanical Engineers (ASME), 1986)The various heat transfer laws describing the response of the hot-wire to the velocity normal to its axis have been evaluated on a common basis to judge their effectiveness in representing ... -
Interfacial Instability of an Oscillating Shear Layer
(The American Society of Mechanical Engineers (ASME), 1986)The oscillating interface between a very viscous fluid layer (which oscillates as a nearly rigid body with the bounding container) and a relatively inviscid layer becomes unstable under certain ...