Journal of Fluids Engineering: Recent submissions
Now showing items 4861-4880 of 9024
-
On the Behavior of Notched Struts
(The American Society of Mechanical Engineers (ASME), 1968)A theoretical buckling load for a strut with a single-edge notch at its mid point is calculated assuming that the effect of the notch is to produce a discontinuity in the slope of the ... -
Elastic-Plastic Stress Distribution in a Compressed Ring
(The American Society of Mechanical Engineers (ASME), 1968)This investigation was conducted to define the plastic stress distribution at a section 90 degrees from the point of load application on a ring. The elastic and plastic stress distribution was ... -
Erratum: “Ductile Creep Rupture of Shells with Strain Hardening and Time-Dependent Loading” (Journal of Basic Engineering, 1968, 90, pp. 297–300)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “The Turbulent Wake of a Body of Revolution” (Chevray, R., 1968, ASME J. Basic Eng., 90, pp. 275–284)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Computerized Method of Characteristics Calculations for Unsteady Pneumatic Line Flows” (Manning, J. R., 1968, ASME J. Basic Eng., 90, pp. 231–240)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Rough Surface Effects on Cavitation Inception” (Arndt, R. E. A., and Ippen, A. T., 1968, ASME J. Basic Eng., 90, pp. 249–261)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Secondary Flow Effects in a Bounded Rectangular Jet” (Foss, J. F., and Jones, J. B., 1968, ASME J. Basic Eng., 90, pp. 241–248)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Effects of Gravity and Surface Tension Upon Liquid Jets Leaving Poiseuille Tubes” (Lienhard, J. H., 1968, ASME J. Basic Eng., 90, pp. 262–268)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “On Real Fluid Flow Over Yawed Circular Cylinders” (Chiu, W. S., and Lienhard, J. H., 1967, ASME J. Basic Eng., 89, pp. 851–857)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Identification of Potential Failure Nuclei in Rolling Contact Fatigue” (Martin, J. A., and Eberhardt, A. D., 1967, ASME J. Basic Eng., 89, pp. 932–942)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Column Separation Accompanying Liquid Transients in Pipes” (Baltzer, R. A., 1967, ASME J. Basic Eng., 89, pp. 837–846)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “An Investigation of Pulsations in the Boiler Feed System of a Central Power Station” (Dussourd, J. L., 1968, ASME J. Basic Eng., 90, pp. 607–616)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “On the Calculation of Unsteady Nonlinear Three-Dimensional Supersonic Flow Past Wings” (Kacprzynski, J. J., Ashley, H., and Sankaranarayanan, R., 1968, ASME J. Basic Eng., 90, pp. 581–594)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Some Correlations of Theory and Experiment for Developing Turbulent Free Shear Layers” (Lamb, J. P., and Bass, R. L., 1968, ASME J. Basic Eng., 90, pp. 572–578)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Investigation of a Method for the General Analysis of Time Dependent Two-Dimensional Laminar Boundary Layers” (Koob, S. J., and Abbott, D. E., 1968, ASME J. Basic Eng., 90, pp. 563–570)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “A Suction Scheme Applied to Flow Through Sudden Enlargement” (Heskestad, G., 1968, ASME J. Basic Eng., 90, pp. 541–552)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Water-Column Separation at Two Pumping Plants” (Brown, R. J., 1968, ASME J. Basic Eng., 90, pp. 521–530)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “An Analytical Study of Separated Flow About Circular Cylinders” (Sarpkaya, T., 1968, ASME J. Basic Eng., 90, pp. 511–518)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “Fluctuating Lift Forces on Aerofoils Moving Through Transverse and Chordwise Gusts” (Horlock, J. H., 1968, ASME J. Basic Eng., 90, pp. 494–500)
(The American Society of Mechanical Engineers (ASME), 1968) -
Discussion: “The Near-Wake of a Circular Cylinder in Crossflow” (Hanson, F. B., and Richardson, P. D., 1968, ASME J. Basic Eng., 90, pp. 476–483)
(The American Society of Mechanical Engineers (ASME), 1968)