Journal of Engineering for Gas Turbines and Power: Recent submissions
Now showing items 3901-3920 of 9564
-
Discussion: “Performance of Stainless-Steel Condenser Tubes” (Pell, Robert H., 1961, ASME J. Eng. Power, 83, pp. 339–341)
(The American Society of Mechanical Engineers (ASME), 1961) -
Discussion: “Development of Cryogenic Heat Pipes” (Eggers, Philip E., and Serkiz, Aleck W., 1971, ASME J. Eng. Power, 93, pp. 279–286)
(The American Society of Mechanical Engineers (ASME), 1971) -
Discussion: “Unbalance Response of an Elastic Rotor in Damped Flexible Bearings at Supercritical Speeds” (Rieger, Neville F., 1971, ASME J. Eng. Power, 93, pp. 265–275)
(The American Society of Mechanical Engineers (ASME), 1971) -
Discussion: “Thermal Cycle Arrangements for Power Plants Employing Dry Cooling Towers” (Leung, Paul, and Moore, R. E., 1971, ASME J. Eng. Power, 93, pp. 257–263)
(The American Society of Mechanical Engineers (ASME), 1971) -
Char Burning MHD Systems
(The American Society of Mechanical Engineers (ASME), 1971)This paper indicates the levels of plant thermal efficiency that might be anticipated from three MHD systems (two burning char and oxygen, one burning char and air) featuring reaction of the ... -
The Role of Chemistry in Gas Turbine Emissions
(The American Society of Mechanical Engineers (ASME), 1971) -
Design of Cascades for Incompressible Plane Potential Flows With Prescribed Velocity Distribution
(The American Society of Mechanical Engineers (ASME), 1971)A method of calculation in designing two-dimensional cascades with given velocity distribution is described. An iterative method of the solution for the integral equation to determine the coordinate ... -
Laboratory Procedures for Evaluating High-Temperature Corrosion Resistance of Gas Turbine Alloys
(The American Society of Mechanical Engineers (ASME), 1971)With an increasing interest in the burning of heavy fuels in gas turbines there is also concern with the precise determination of the corrosive effects which may arise from the use of these ... -
The Role of Chloride in the Corrosion Caused by Flue Gases and Their Deposits
(The American Society of Mechanical Engineers (ASME), 1971)The role of chloride in the corrosion of oil- and coal-fired boilers and gas turbines, by flue gases and their deposits, is discussed, on the basis of both experimental and theoretical studies. ... -
Analysis of the Dynamics of Gas Turbines and Their Control Systems
(The American Society of Mechanical Engineers (ASME), 1971)The gas turbine units designed by the Neva Works named after V. I. Lenin (NZL) are intended for driving the gas trunkline compressors and electrical generators, and are also used in chemical ... -
A Survey of Nitrogen-Oxides Control Technology and the Development of a Low NOx Emissions Combustor
(The American Society of Mechanical Engineers (ASME), 1971)The problem of NOx emissions reduction is gaining increased attention from those concerned with air pollution control activities. HEW proposes to issue criteria for the control of nitrogen oxides ... -
Discussion: “A Thermodynamic Analysis for Detonation Free Engine Performance” (Powell, C. K., Alford, R. N., Chen, T. N., and Kevorkian, V., 1970, ASME J. Eng. Power, 92, pp. 231–238)
(The American Society of Mechanical Engineers (ASME), 1971) -
Discussion: “Vacuum Deaerator Design” (Kingsbury, A. W., and Phillips, E. L., 1961, ASME J. Eng. Power, 83, pp. 331–335)
(The American Society of Mechanical Engineers (ASME), 1961) -
Discussion: “Design of Cascades for Incompressible Plane Potential Flows With Prescribed Velocity Distribution” (Schwering, W., 1971, ASME J. Eng. Power, 93, pp. 321–331)
(The American Society of Mechanical Engineers (ASME), 1971) -
Discussion: “Laboratory Procedures for Evaluating High-Temperature Corrosion Resistance of Gas Turbine Alloys” (Lee, S. Y., DeCorso, S. M., and Young, W. E., 1971, ASME J. Eng. Power, 93, pp. 313–320)
(The American Society of Mechanical Engineers (ASME), 1971) -
Discussion: “The Role of Chloride in the Corrosion Caused by Flue Gases and Their Deposits” (Cutler, A. J. B., Halstead, W. D., Laxton, J. W., and Stevens, C. G., 1971, ASME J. Eng. Power, 93, pp. 307–312)
(The American Society of Mechanical Engineers (ASME), 1971) -
Discussion: “Analysis of the Dynamics of Gas Turbines and Their Control Systems” (Sarantsev, L. B., 1971, ASME J. Eng. Power, 93, pp. 300–306)
(The American Society of Mechanical Engineers (ASME), 1971) -
Discussion: “A Survey of Nitrogen-Oxides Control Technology and the Development of a Low NOx Emissions Combustor” (Tomany, J. P., Koppang, R. R., and Burge, H. L., 1971, ASME J. Eng. Power, 93, pp. 293–299)
(The American Society of Mechanical Engineers (ASME), 1971) -
Heat Transfer to an Airfoil in Oscillating Flow
(The American Society of Mechanical Engineers (ASME), 1971)Local heat transfer coefficients to an airfoil in an oscillating stream have been measured for a range of frequencies and oscillation amplitudes. Results at moderate angles of attack are in ... -
A Blade Theory of an Impeller With an Arbitrary Surface of Revolution
(The American Society of Mechanical Engineers (ASME), 1971)In this report a method of analyzing subsonic inviscid flow between blades on a stream surface of revolution of a turbomachine, which may be an axial, a radial, or a mixed-flow type, is ...