Journal of Aerospace Engineering: Recent submissions
Now showing items 661-680 of 2488
-
Wind Tunnel Investigations of Aeroelastic Electricity Transmission Tower under Synoptic and Typhoon Winds
(ASCE, 1/1/2021)Wind tunnel tests of an aeroelastic tower model at a length scale of 1∶40 were conducted to investigate the dynamic responses of an electricity transmission tower under synoptic and typhoon winds. The aeroelastic tower ... -
On-Site Measured Gust Response Factors of Transmission Towers Based on SHM System
(ASCE, 1/1/2021)Many transmission towers have collapsed during typhoon events, and the design wind loads in most current standards consider only the turbulence characteristics of monsoons. The gust response factor (GRF) is a parameter ... -
Spatial Tailoring of a Metal-Ceramic Composite Panel Subjected to High-Speed Flow
(ASCE, 1/1/2021)In this paper, an optimization-based computational framework for the spatial tailoring of a metal-ceramic composite panel subjected to high-speed flow is discussed. The framework includes the modeling, evaluation, and ... -
New Cone-Rolling Principle and Its Application for the Underactuated Attitude Maneuver Optimization of a Rigid Body
(ASCE, 1/1/2021)The global optimal solution for the underactuated attitude maneuver plays a significant role in the fields of spacecraft, robotics, and mechanics. This paper investigated the global optimal underactuated attitude maneuver ... -
Assessments of Structural Health Monitoring for Fatigue Cracks in Metallic Structures by Using Lamb Waves Driven by Piezoelectric Transducers
(ASCE, 1/1/2021)In this paper, the assessments of structural health monitoring (SHM) for metallic structures are presented. Tests were conducted on three specimens for fatigue crack testing and damage index measurements. In each specimen, ... -
Stabilization of the Cyclic Response of the Ni49.9 Ti50.1 Shape Memory Actuators under Thermomechanical Loads
(ASCE, 1/1/2021)This work is focused on the development of a novel strategy to achieve dimensional stability for 55NiTi actuators that operate at a relatively higher temperature; i.e., with an austenite finish temperature, Af, greater ... -
Computational Multiscale Analysis of the Mechanical Behavior of Radially Grown Carbon Nanotube Architecture
(ASCE, 11/1/2020 )An atomistically-informed multiscale modeling framework is extended to assess the improvement in mechanical properties of unidirectional fiber-reinforced polymer composites with radially-grown carbon nanotube (CNT) ... -
Seismic Response Analyses of Transmission Towers under Multidimensional Ground Motions with Rocking and Torsion Components
(ASCE, 11/1/2020 )Most current studies on the seismic responses of transmission towers are performed using two or three translational components of ground motion as earthquake inputs. In this study, a novel surface fitting method (SFM) for ... -
Active Disturbance Rejection Control for Hypersonic Flutter Suppression Based on Parametric ROM
(ASCE, 11/1/2020 )This paper presents an active disturbance rejection control algorithm (ADRC) to suppress the hypersonic flutter of a three-degrees-of-freedom (3-DOF) two-dimensional (2D) airfoil operating in multiparameters space. In this ... -
Short Landing Performance and Scale Effect of a Flapping Wing Aircraft
(ASCE, 11/1/2020 )An investigation was made into the performance and scale effect of birdlike flapping wing aircraft in short landing. A flapping mechanism is proposed to transform a powered shaft rotation to an optimal kinematics of wing ... -
Improved Method to Determine Young’s Modulus for Concrete Cylinder Using Electromechanical Spectrum: Principle and Validation
(ASCE, 11/1/2020 )Electromechanical impedance (EMI) has been used as an in-situ nondestructive testing (NDT) method for concrete material property testing, e.g., strength and Young’s modulus, for decades. However, current EMI methods ... -
Early Onset Prediction for Rotors in Vortex Ring State
(ASCE, 11/1/2020 )The OpenFOAM version 5.0 CFD package was used to investigate detection methods for a small quadrotor drone entering the vortex-ring state. The vortex-ring state causes increased thrust peak-to-mean fluctuations that can ... -
Influence of the Upstream Wakes on the Boundary Layer of a High-Lift Low-Pressure Turbine at Positive Incidence
(ASCE, 11/1/2020 )The wake-induced transition, natural transition, and instability induced by the Klebanoff streaks complicate the transition process. In this paper, the boundary layer on the suction surface of a high-lift low-pressure ... -
Experimental and Numerical Investigations of the Effect of Bolt Position on the Mixed-Mode Fracture Strength of Edge Crack Specimens
(ASCE, 11/1/2020 )Experimental and numerical investigations were conducted to evaluate the effect of bolt position along the crack length on the mixed-mode fracture strength and effective stress intensity geometry/loading factor. The ... -
Stability Improvement of a High-Pressure Ratio Centrifugal Compressor by Flow Injection
(ASCE, 11/1/2020 )High-pressure ratio centrifugal compressors are required in modern turboshaft engines with the requirements of a high power-to-weight ratio and low fuel consumption. The reduction of the stable flow range is one of the ... -
Neighboring Optimal Guidance and Attitude Control of Low-Thrust Earth Orbit Transfers
(ASCE, 11/1/2020 )Recently, low-thrust propulsion is gaining strong interest from the research community and has already found application in some mission scenarios. This paper proposes an integrated guidance and control methodology, termed ... -
Solutions to Planar Aircraft Perching Problem Utilizing Sideslip Maneuvering
(ASCE, 11/1/2020 )This paper presents a dynamic analysis, optimization framework, and control formulation of a sideslip maneuvering technique that can be implemented in a two-dimensional (2D) planar perching problem. This aggressive maneuver ... -
Attitude-Orbit Cooperative Control for Small-Scale Spacecraft with Chemical Propulsion: Adaptive Sliding Mode Control Based on Neural Network
(ASCE, 11/1/2020 )A novel, effective, and feasible attitude-orbit cooperative control algorithm with adaptive sliding mode control and neural network is developed in this study. The algorithm is analyzed and investigated for the problem of ... -
Testing of the Aerodynamic Characteristics of an Inflatable Airfoil Section
(ASCE, 9/1/2020 1)Inflatable structures are characterized by being light and easy to manufacture and deploy. Hence, they find many applications in aerospace and aeronautical engineering. In this paper, an inflatable segment with a The ... -
Deployment Dynamics for a Flexible Solar Array Composed of Composite-Laminated Plates
(ASCE, 11/1/2020 )Modern spacecraft often deploy large-scale and lightweight solar arrays consisting of composite-laminated plates because of their high reliability, superior mechanical properties, and low manufacturing cost. This paper ...