| contributor author | E. G. Thomsen | |
| contributor author | H. H. Thomsen | |
| date accessioned | 2017-05-09T01:38:30Z | |
| date available | 2017-05-09T01:38:30Z | |
| date copyright | November, 1974 | |
| date issued | 1974 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27616#1216_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/164954 | |
| description abstract | The history of wire drawing through dies is reviewed and the description of the process by Theophilus, dating from about 1100 A.D., is discussed. It can be assumed that the fact that this early metal worker did not mention a die angle was due to his lack of knowledge of its function. It is suggested that deburred holes, or holes in which the boring operation inherently produced conical surfaces possibly were sufficient to make the wire drawing process successful without the operator knowing the reasons for his success. The recent data presented by Okolo and Wistreich seem to confirm that wire drawing is possible over a wide range of operating conditions and die angles. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Early Wire Drawing Through Dies | |
| type | Journal Paper | |
| journal volume | 96 | |
| journal issue | 4 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3438498 | |
| journal fristpage | 1216 | |
| journal lastpage | 1221 | |
| identifier eissn | 1528-8935 | |
| keywords | Wire drawing AND Metalworkers | |
| tree | Journal of Manufacturing Science and Engineering:;1974:;volume( 096 ):;issue: 004 | |
| contenttype | Fulltext | |