Show simple item record

contributor authorSalem, M. R.
contributor authorElshazly, K. M.
contributor authorSakr, R. Y.
contributor authorAli, R. K.
date accessioned2017-05-09T01:23:42Z
date available2017-05-09T01:23:42Z
date issued2015
identifier issn1948-5085
identifier othertsea_007_01_011005.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/159680
description abstractThe present work experimentally investigates the characteristics of convective heat transfer in horizontal shell and coil heat exchangers in addition to friction factor for fully developed flow through the helically coiled tube (HCT). The majority of previous studies were performed on HCTs with isothermal and isoflux boundary conditions or shell and coil heat exchangers with small ranges of HCT configurations and fluid operating conditions. Here, five heat exchangers of counterflow configuration were constructed with different HCTcurvature ratios (خ´) and tested at different mass flow rates and inlet temperatures of the two sides of the heat exchangers. Totally, 295 test runs were performed from which the HCTside and shellside heat transfer coefficients were calculated. Results showed that the average Nusselt numbers of the two sides of the heat exchangers and the overall heat transfer coefficients increased by increasing coil curvature ratio. The average increase in the average Nusselt number is of 160.3–80.6% for the HCT side and of 224.3–92.6% for the shell side when خ´ increases from 0.0392 to 0.1194 within the investigated ranges of different parameters. Also, for the same flow rate in both heat exchanger sides, the effect of coil pitch and number of turns with the same coil torsion and tube length is remarkable on shell average Nusselt number while it is insignificant on HCTaverage Nusselt number. In addition, a significant increase of 33.2–7.7% is obtained in the HCTFanning friction factor (fc) when خ´ increases from 0.0392 to 0.1194. Correlations for the average Nusselt numbers for both heat exchanger sides and the HCT Fanning friction factor as a function of the investigated parameters are obtained.
publisherThe American Society of Mechanical Engineers (ASME)
titleExperimental Investigation of Coil Curvature Effect on Heat Transfer and Pressure Drop Characteristics of Shell and Coil Heat Exchanger
typeJournal Paper
journal volume7
journal issue1
journal titleJournal of Thermal Science and Engineering Applications
identifier doi10.1115/1.4028612
journal fristpage11005
journal lastpage11005
identifier eissn1948-5093
treeJournal of Thermal Science and Engineering Applications:;2015:;volume( 007 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record