| contributor author | S. Fujii | |
| contributor author | M. F. DeVries | |
| contributor author | S. M. Wu | |
| date accessioned | 2017-05-09T01:03:04Z | |
| date available | 2017-05-09T01:03:04Z | |
| date copyright | November, 1971 | |
| date issued | 1971 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27566#1093_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/153311 | |
| description abstract | Following the investigation of drill point geometry previously reported [1, 2], the chisel edge profile and the chisel edge angle are analyzed mathematically. The relationship between the cone semiangle, θ, and the x-coordinate of the cone vertex, −d, is derived for a given chisel edge angle and nominal relief angle at the outer corner. This relationship is used to study the effects of grinding cone parameters on drill point geometry. The analysis indicates the existence of an optimum θ value for best drill performance. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Analysis of the Chisel Edge and the Effect of the d-Theta Relationship on Drill Point Geometry | |
| type | Journal Paper | |
| journal volume | 93 | |
| journal issue | 4 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3428048 | |
| journal fristpage | 1093 | |
| journal lastpage | 1105 | |
| identifier eissn | 1528-8935 | |
| keywords | Drills (Tools) | |
| keywords | Chisels | |
| keywords | Geometry | |
| keywords | Corners (Structural elements) AND Grinding | |
| tree | Journal of Manufacturing Science and Engineering:;1971:;volume( 093 ):;issue: 004 | |
| contenttype | Fulltext | |