Show simple item record

contributor authorD. N. Borza
contributor authorI. T. Nistea
date accessioned2017-05-09T00:49:23Z
date available2017-05-09T00:49:23Z
date copyright41244
date issued2012
identifier issn1528-9044
identifier otherJEPAE4-926513#ep_134_4_041007.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/148566
description abstractReliability of electronic assemblies at board level and solder joint integrity depend upon the stress applied to the assembly. The stress is often of thermomechanical or of vibrational nature. In both cases, the behavior of the assembly is strongly influenced by the mechanical boundary conditions created by the printed circuit board (PCB) to casing fasteners. In many previously published papers, the conditions imposed to the fasteners are mostly aiming at an increase of the fundamental frequency and a decrease of static or dynamic displacement values characterizing the deformation. These conditions aim at reducing the fatigue in different parts of these assemblies. In the photomechanics laboratory of INSA Rouen, the origins of solder joint failure have been investigated by means of full-field measurements of the flexure deformation induced by vibrations or by forced thermal convection. The measurements were done both at a global level for the whole printed circuit board assembly (PCBA) and at a local level at the solder joints where failure was reported. The experimental technique used was phase-stepped laser speckle interferometry. This technique has a submicrometer sensitivity with respect to out-of-plane deformations induced by bending and its use is completely nonintrusive. Some of the results were comforted by comparison with a numerical finite elements model. The experimental results are presented either as time-average holographic fringe patterns, as in the case of vibrations, or as wrapped phase patterns, as in the case of deformation under thermomechanical stress. Both types of fringe patterns may be processed so as to obtain the explicit out-of-plane static deformation (or vibration amplitude) maps. Experimental results show that the direct cause of solder joint failure may be a high local PCB curvature produced by a supplementary fastening screw intended to reduce displacements and increase fundamental frequency. The curvature is directly responsible for tensile stress appearing in the leads of a large quad flat pack (QFP) component and for shear in the corresponding solder joints. The general principle of increasing the fundamental frequency and decreasing the static or dynamic displacement values has to be checked against the consequences on the PCB curvature near large electronic devices having high stiffness.
publisherThe American Society of Mechanical Engineers (ASME)
titleExperimental Investigation by Speckle Interferometry of Solder Joint Failure Under Thermomechanical Load Aggravated by Boundary Conditions at Board Level
typeJournal Paper
journal volume134
journal issue4
journal titleJournal of Electronic Packaging
identifier doi10.1115/1.4007812
journal fristpage41007
identifier eissn1043-7398
keywordsDeformation
keywordsMeasurement
keywordsInterferometry
keywordsScrews
keywordsStress
keywordsDiffraction patterns
keywordsVibration
keywordsBoundary-value problems
keywordsDisplacement
keywordsFailure
keywordsSolder joints
keywordsPrinted circuit board assemblies
keywordsReliability
keywordsBending (Stress)
keywordsManufacturing AND Fatigue
treeJournal of Electronic Packaging:;2012:;volume( 134 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record