Modeling Embryo Transfer into a Closed Uterine Cavity

Abstract

Embryo transfer (ET) is the last manual intervention after extracorporeal fertilization. After the ET procedure is completed, the embryos are conveyed in the uterus for another two to four days due to spontaneous uterine peristalsis until the window time for implantation. The role of intrauterine fluid flow patterns in transporting the embryos to their implantation site during and after ET was simulated by injection of a liquid bolus into a two-dimensional liquid-filled channel with a closed fundal end via a liquid-filled catheter inserted in the channel. Numerical experiments revealed that the intrauterine fluid field and the embryos transport pattern were strongly affected by the closed fundal end. The embryos re-circulated in small loops around the vicinity where they were deposited from the catheter. The transport pattern was controlled by the uterine peristalsis factors, such as amplitude and frequency of the uterine walls motility, as well as the synchronization between the onset of catheter discharge and uterine peristalsis. The outcome of ET was also dependent on operating parameters such as placement of the catheter tip within the uterine cavity and the delivery speed of the catheter load. In conclusion, this modeling study highlighted important parameters that should be considered during ET procedures in order to increase the potential for pregnancy success.