Show simple item record

contributor authorG. Lorenzini
contributor authorC. Biserni
contributor authorL. A. Isoldi
contributor authorL. A. O. Rocha
contributor authorE. D. dos Santos
date accessioned2017-05-09T00:43:06Z
date available2017-05-09T00:43:06Z
date copyrightDecember, 2011
date issued2011
identifier issn1528-9044
identifier otherJEPAE4-26319#041008_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/145770
description abstractIn this paper, we rely on the Constructal method to optimize the geometry of a Y-shaped cavity embedded into a solid conducting wall. The structure has four degrees of freedom. The objective is to minimize the global thermal resistance between the solid and the cavity. The optimization procedure has demonstrated that for larger solids, a cavity shaped as T led to a minimization of the global thermal resistance, while the opposite effect is observed for tall solids, where the optimal shapes are reached when the bifurcated branches deeply penetrates the solid in the vertical direction, according to the Constructal principle of “optimal distribution of imperfections”. The three times minimized global thermal resistance of the Y-shaped cavity has been correlated by power laws as a function of its corresponding optimal configurations. Finally, the performance of the Y-shaped intrusion proved to be superior to that of other basic geometries: the optimized global thermal resistances of the Y-shaped cavities obtained for H/L = 1.0, 2.0, and 5.0 were, respectively 66.61%, 55.37%, and 19.05% lower than the optimal T-shaped cavities under the same thermal and geometric conditions. Furthermore, in comparison with the “finger cavity” shaped as C, the Y-shaped cavities increased the thermal performance in 109.12%, 84.45%, 59.32%, and 20.10% for H/L = 0.5, 1.0, 2.0, and 5.0, respectively.
publisherThe American Society of Mechanical Engineers (ASME)
titleConstructal Design Applied to the Geometric Optimization of Y-shaped Cavities Embedded in a Conducting Medium
typeJournal Paper
journal volume133
journal issue4
journal titleJournal of Electronic Packaging
identifier doi10.1115/1.4005296
journal fristpage41008
identifier eissn1043-7398
keywordsCavities
keywordsGeometry
keywordsShapes
keywordsThermal resistance
keywordsDesign
keywordsOptimization
keywordsDegrees of freedom AND Bifurcation
treeJournal of Electronic Packaging:;2011:;volume( 133 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record