Show simple item record

contributor authorYves Deyrail
contributor authorSerge Kaliaguine
contributor authorFrej Mighri
date accessioned2017-05-09T00:33:28Z
date available2017-05-09T00:33:28Z
date copyrightMay, 2009
date issued2009
identifier issn2381-6872
identifier otherJFCSAU-28937#021309_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/140875
description abstractThe aim of this work is to improve the porosity of gas diffusion layers (GDLs) for proton exchange membrane fuel cell electrodes. These GDLs are made by twin-screw extrusion process from conductive formulations composed of polyamide11 (PA11)/polystyrene (PS) as the polymer matrix phase and an appropriate mixture of carbon black (CB) and graphite (GR) as the conductive additives. Final GDL porosity, especially macroporosity, was generated by selective extraction of the PS phase using adequate solvents. Since the generation of pores was found to be directly related to blend morphology, several blend compositions were studied and small amounts (2–6 wt %) of montmorillonite (MMT) clay were used as compatibilizer to improve the dispersion of the PS phase inside the PA11. It was observed that, although GDL volume porosity was not or slightly affected by the addition of MMT compatibilizer, its pore specific surface area was clearly increased. For GDLs made from a blend composed of 65 wt % of PA11/PS (30/70) and 35 wt % of GB/GR (57/43), an increase from 53 m2/g (with no MMT) to around 75 m2/g (with 2 wt % MMT) was obtained. This improvement within the addition of MMT was attributed to the modification of the dispersion state of PS phase. Such modification led to a higher connectivity of pores and consequently more accessibility to the micro/mesopores of CB and GR. The major changes observed with the incorporation of MMT compatibilizer were obtained for the small pore sizes (in the range of 10–400 nm). Depending on MMT content, a considerable shift of pore size distribution in this range to smaller or higher values was obtained. Then the MMT compatibilization could be considered as an interesting route to tailor GDL porous properties.
publisherThe American Society of Mechanical Engineers (ASME)
titleDevelopment of Micro- to Macropores in Conductive Polymer-Based Gas Diffusion Layers for Proton Exchange Membrane Fuel Cells
typeJournal Paper
journal volume6
journal issue2
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.3080558
journal fristpage21309
identifier eissn2381-6910
keywordsPorosity
keywordsGas diffusion layers
keywordsPolymers
keywordsExtruding AND Proton exchange membrane fuel cells
treeJournal of Fuel Cell Science and Technology:;2009:;volume( 006 ):;issue: 002
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record