Show simple item record

contributor authorAmit Gefen
contributor authorEinat Haberman
date accessioned2017-05-09T00:22:41Z
date available2017-05-09T00:22:41Z
date copyrightDecember, 2007
date issued2007
identifier issn0148-0731
identifier otherJBENDY-26773#924_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/135202
description abstractPressure-related deep tissue injury (DTI) is a life-risking form of pressure ulcers threatening immobilized and neurologically impaired patients. In DTI, necrosis of muscle and enveloping adipose tissues occurs under intact skin, owing to prolonged compression by bony prominences. Modeling the process of DTI in the buttocks requires knowledge on viscoelastic mechanical properties of the white adipose tissue covering the gluteus muscles. However, this information is missing in the literature. Our major objectives in this study were therefore to (i) measure short-term (HS) and long-term (HL) aggregate moduli of adipose tissue covering the glutei of sheep, (ii) determine the effects of preconditioning on HS and HL, and (iii) determine the time course of stress relaxation in terms of the transient aggregate modulus H(t) in nonpreconditioned (NPC) and preconditioned (PC) tissues. We tested 20 fresh tissue specimens (from 20 mature animals) in vitro: 10 specimens in confined compression for obtaining the complete H(t) response to a ramp-and-hold protocol (ramp rate of 300mm∕s), and 10 other specimens in swift indentations for obtaining comparable short-term elastic moduli at higher ramp rates (2000mm∕s). We found that HS in confined compression were 28.9±14.9kPa and 18.1±6.9kPa for the NPC and PC specimens, respectively. The HL property, 10.3±4.2kPa, was not affected by preconditioning. The transient aggregate modulus H(t) always reached the plateau phase (less than 10% difference between H(t) and HL) within 2min, which is substantially shorter than the times for DTI onset reported in previous animal studies. The short-term elastic moduli at high indentation rates were 22.6±10kPa and 15.8±9.4kPa for the NPC and PC test conditions, respectively. Given a Poisson’s ratio of 0.495, comparison of short-term elastic moduli between the high and slow rate tests indicated a strong deformation-rate dependency. The most relevant property for modeling adipose tissue as related to DTI is found to be HL, which is conveniently unaffected by preconditioning. The mechanical characteristics of white adipose tissue provided herein are useful for analytical as well as numerical models of DTI, which are essential for understanding this serious malady.
publisherThe American Society of Mechanical Engineers (ASME)
titleViscoelastic Properties of Ovine Adipose Tissue Covering the Gluteus Muscles
typeJournal Paper
journal volume129
journal issue6
journal titleJournal of Biomechanical Engineering
identifier doi10.1115/1.2800830
journal fristpage924
journal lastpage930
identifier eissn1528-8951
keywordsStress
keywordsBiological tissues
keywordsCompression
keywordsMuscle
keywordsRelaxation (Physics)
keywordsCycles
keywordsMechanical properties
keywordsElastic moduli AND Modeling
treeJournal of Biomechanical Engineering:;2007:;volume( 129 ):;issue: 006
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record