| contributor author | Takashi Ueda | |
| contributor author | Akira Hosokawa | |
| contributor author | Keiji Yamada | |
| date accessioned | 2017-05-09T00:20:48Z | |
| date available | 2017-05-09T00:20:48Z | |
| date copyright | February, 2006 | |
| date issued | 2006 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27914#130_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/134209 | |
| description abstract | In this paper, the influence of oil mist on the tool temperature in cutting is investigated experimentally. The turning of a carbon steel with oil mist applied is performed, and the temperature of the alumina tool at the tool-chip interface is measured using a two-color pyrometer. The tool temperature in dry cutting at a cutting speed of 300 m/min is ∼1060°C, but it is ∼1000°C when oil mist is supplied. In intermittent turning, the oil mist has more effect on the tool temperature because it is supplied more efficiently to the tool-chip interface. In end milling with the oil mist applied, the tool temperature at the flank face is ∼580°C at a cutting speed of 400 m/min, though in dry cutting it is ∼660°C. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Effect of Oil Mist on Tool Temperature in Cutting | |
| type | Journal Paper | |
| journal volume | 128 | |
| journal issue | 1 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.2039099 | |
| journal fristpage | 130 | |
| journal lastpage | 135 | |
| identifier eissn | 1528-8935 | |
| keywords | Temperature | |
| keywords | Cutting | |
| keywords | Milling AND Turning | |
| tree | Journal of Manufacturing Science and Engineering:;2006:;volume( 128 ):;issue: 001 | |
| contenttype | Fulltext | |