| contributor author | Eric H. K. Fung | |
| contributor author | S. M. Yang | |
| date accessioned | 2017-05-09T00:05:19Z | |
| date available | 2017-05-09T00:05:19Z | |
| date copyright | November, 2001 | |
| date issued | 2001 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27525#567_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/125479 | |
| description abstract | This paper describes a methodology of online measuring and compensating spindle error motions without using a precalibrated master. The method is based on a combination of forecasting compensatory control (FCC) and error separation techniques. The real time recursive ARMA modeling technique is used for the modeling and forecasting of workpiece errors while the error compensation is performed by means of two-dimensional piezo-actuated tool movements. Experimental results have shown that an improvement of 42–47 percent was achieved for the roundness error of workpieces in the taper turning operations. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | A New Method for Roundness Control in Taper Turning Using FCC Techniques | |
| type | Journal Paper | |
| journal volume | 123 | |
| journal issue | 4 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.1372196 | |
| journal fristpage | 567 | |
| journal lastpage | 575 | |
| identifier eissn | 1528-8935 | |
| keywords | Motion | |
| keywords | Spindles (Textile machinery) | |
| keywords | Errors | |
| keywords | Turning AND Error compensation | |
| tree | Journal of Manufacturing Science and Engineering:;2001:;volume( 123 ):;issue: 004 | |
| contenttype | Fulltext | |